Discussion
Home ‣ Mechanical Engineering ‣ Production Engineering Comments
- Question
The rake angle of a single point cutting tool corresponds to __________ of a twist drill.
Options- A. lip clearance angle
- B. helix angle
- C. point angle
- D. chisel edge angle
- Correct Answer
- helix angle
- 1. The width of cutting edge of a parting-off tool varies from
Options- A. 3 to 12 mm
- B. 5 to 20 mm
- C. 8 to 30 mm
- D. 15 to 40 mm Discuss
- 2. Small nose radius
Options- A. increases tool life
- B. decreases tool life
- C. produces chipping and decreases tool life
- D. results in excessive stress concentration and greater heat generation Discuss
- 3. Soft materials can not be economically ground due to
Options- A. high temperature involved
- B. frequent wheel clogging
- C. rapid wheel wear
- D. low work piece stiffness Discuss
- 4. The process of removing metal by a cutter which is rotated in the same direction of travel of workpiece, is called
Options- A. up milling
- B. down milling
- C. face milling
- D. end milling Discuss
- 5. The chamfering is an operation of
Options- A. bevelling the extreme end of a workpiece
- B. embossing a diamond shaped pattern on the surface of a workpiece
- C. reducing the diameter of a workpiece over a very narrow surface
- D. enlarging the end of a hole cylindrically Discuss
- 6. The operation of machining several surfaces of a workpiece simultaneously is called
Options- A. profile milling
- B. gang milling
- C. saw milling
- D. helical milling Discuss
- 7. Crater wear leads to
Options- A. increase in cutting temperature
- B. weakening of tool
- C. friction and cutting forces
- D. all of these Discuss
- 8. The tool life in case of a grinding wheel is the time
Options- A. between two successive regrinds of the wheel
- B. taken for the wheel to be balanced
- C. taken between two successive wheel dressings
- D. taken for a wear of 1 mm on its diameter Discuss
- 9. The plunge grinding requires very __________ speed.
Options- A. high
- B. low Discuss
- 10. The factor considered for evaluation of machinability is
Options- A. cutting forces and power consumption
- B. tool life
- C. type of chips and shear angle
- D. all of these Discuss
Production Engineering problems
Search Results
Correct Answer: 3 to 12 mm
Correct Answer: results in excessive stress concentration and greater heat generation
Correct Answer: frequent wheel clogging
Correct Answer: down milling
Correct Answer: bevelling the extreme end of a workpiece
Correct Answer: gang milling
Correct Answer: all of these
Correct Answer: taken between two successive wheel dressings
Correct Answer: low
Correct Answer: all of these
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.