Discussion
Home ‣ Mechanical Engineering ‣ Production Engineering Comments
- Question
As the cutting speed increases, the tool cutting forces
Options- A. remain constant
- B. increases
- C. decreases
- D. first increases and then decreases
- Correct Answer
- decreases
- 1. If the shear angle is large and the chip-tool contact area is low, then the tool life will be more.
Options- A. Correct
- B. Incorrect Discuss
- 2. The tool may fail due to
Options- A. cracking at the cutting edge due to thermal stresses
- B. chipping of the cutting edge
- C. plastic deformation of the cutting edge
- D. all of these Discuss
- 3. The grinding of long, slender shafts or bars is usually done by
Options- A. infeed grinding
- B. through feed grinding
- C. endfeed grinding
- D. any one of these Discuss
- 4. In twist fluted drills, chips do not move out automatically.
Options- A. Correct
- B. Incorrect Discuss
- 5. The hard grade grinding wheels are denoted by the letters
Options- A. A to H
- B. I to P
- C. Q to Z
- D. A to P Discuss
- 6. In machining metal, cutting force at the cutting edge is measured by a
Options- A. wattmeter
- B. dynamometer
- C. hydrometer
- D. pyrometer Discuss
- 7. A feed gear box for a screw cutting lathe is designed on the basis of
Options- A. geometric progression
- B. arithmetic progression
- C. harmonic progression
- D. none of these Discuss
- 8. The tailstock set over required to turn a taper on the entire length of a workpiece having diameters D and d is
Options- A.
- B.
- C.
- D. D - d Discuss
- 9. In ultra-sonic machining, tool is made of
Options- A. tungsten carbide
- B. brass or copper
- C. diamond
- D. stainless steel Discuss
- 10. In oblique cutting system, the tool may or may not generate a surface parallel to the workface.
Options- A. Yes
- B. No Discuss
Production Engineering problems
Search Results
Correct Answer: Correct
Correct Answer: all of these
Correct Answer: through feed grinding
Correct Answer: Incorrect
Correct Answer: Q to Z
Correct Answer: dynamometer
Correct Answer: geometric progression
Correct Answer:
Correct Answer: brass or copper
Correct Answer: Yes
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.