Discussion
Home ‣ Mechanical Engineering ‣ Production Engineering Comments
- Question
The hard grade grinding wheels are denoted by the letters
Options- A. A to H
- B. I to P
- C. Q to Z
- D. A to P
- Correct Answer
- Q to Z
- 1. In American Standard Association (A S A) system, if the tool nomenclature is 8-6-5-5-10-15-2 mm, then the side rake angle will be
Options- A. 5°
- B. 6°
- C. 8°
- D. 10° Discuss
- 2. The angle formed by the leading edge of the land with a plane having the axis of the drill, is called
Options- A. helix or rake angle
- B. point angle
- C. chisel edge angle
- D. lip clearance angle Discuss
- 3. The process of removing metal by a cutter which is rotated against the direction of travel of workpiece, is called
Options- A. up milling
- B. down milling
- C. face milling
- D. end milling Discuss
- 4. In centreless grinding, work place centre will be
Options- A. above the line joining the two wheel centres
- B. below the line joining the two wheel centres
- C. on the line joining the two wheel centres
- D. at the intersection of the line joining the wheel centres with the work place plane Discuss
- 5. In drilling brass, a drill with
Options- A. zero helix angle is used
- B. low helix angle is used
- C. high helix angle is used
- D. any helix angle can be used Discuss
- 6. In twist fluted drills, chips do not move out automatically.
Options- A. Correct
- B. Incorrect Discuss
- 7. The grinding of long, slender shafts or bars is usually done by
Options- A. infeed grinding
- B. through feed grinding
- C. endfeed grinding
- D. any one of these Discuss
- 8. The tool may fail due to
Options- A. cracking at the cutting edge due to thermal stresses
- B. chipping of the cutting edge
- C. plastic deformation of the cutting edge
- D. all of these Discuss
- 9. If the shear angle is large and the chip-tool contact area is low, then the tool life will be more.
Options- A. Correct
- B. Incorrect Discuss
- 10. As the cutting speed increases, the tool cutting forces
Options- A. remain constant
- B. increases
- C. decreases
- D. first increases and then decreases Discuss
Production Engineering problems
Search Results
Correct Answer: 6°
Correct Answer: helix or rake angle
Correct Answer: up milling
Correct Answer: above the line joining the two wheel centres
Correct Answer: low helix angle is used
Correct Answer: Incorrect
Correct Answer: through feed grinding
Correct Answer: all of these
Correct Answer: Correct
Correct Answer: decreases
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.