Discussion
Home ‣ Mechanical Engineering ‣ Production Engineering Comments
- Question
In oblique cutting of metals, the cutting edge of the tool is
Options- A. perpendicular to the workpiece
- B. perpendicular to the direction of tool travel
- C. parallel to the direction of tool travel
- D. inclined at an angle less than 90° to the direction of tool travel
- Correct Answer
- inclined at an angle less than 90° to the direction of tool travel
- 1. The grinding wheel speed (surface speed in m/min) usually varies from
Options- A. 500 to 1000
- B. 1000 to 1500
- C. 1500 to 2000
- D. 2000 to 2500 Discuss
- 2. In conventional milling, the cutting force tends to lift the work.
Options- A. True
- B. False Discuss
- 3. The operation of producing grooves around the periphery of a cylindrical or conical workpiece is called
Options- A. profile milling
- B. gang milling
- C. saw milling
- D. helical milling Discuss
- 4. The relation between the tool life (T) in minutes and cutting speed (V) in m/min is (where n = An exponent, which depends upon the tool and workpiece, and C = A constant)
Options- A. VnT = C
- B. VTn = C
- C. Vn/T = C
- D. V/Tn = C Discuss
- 5. In which of the following machine, the work is usually rotated while the drill is fed into work?
Options- A. Sensitive drilling machine
- B. Radial drilling machine
- C. Gang drilling machine
- D. Deep hole drilling machine Discuss
- 6. Up milling is also called conventional milling.
Options- A. Agree
- B. Disagree Discuss
- 7. Ceramic tools has greater tool life than carbide tools.
Options- A. True
- B. False Discuss
- 8. In drilling brass, a drill with
Options- A. zero helix angle is used
- B. low helix angle is used
- C. high helix angle is used
- D. any helix angle can be used Discuss
- 9. In centreless grinding, work place centre will be
Options- A. above the line joining the two wheel centres
- B. below the line joining the two wheel centres
- C. on the line joining the two wheel centres
- D. at the intersection of the line joining the wheel centres with the work place plane Discuss
- 10. The process of removing metal by a cutter which is rotated against the direction of travel of workpiece, is called
Options- A. up milling
- B. down milling
- C. face milling
- D. end milling Discuss
Production Engineering problems
Search Results
Correct Answer: 1500 to 2000
Correct Answer: True
Correct Answer: helical milling
Correct Answer: VTn = C
Correct Answer: Deep hole drilling machine
Correct Answer: Agree
Correct Answer: True
Correct Answer: low helix angle is used
Correct Answer: above the line joining the two wheel centres
Correct Answer: up milling
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.