Discussion
Home ‣ Mechanical Engineering ‣ Production Engineering Comments
- Question
The lathe centres are provided with standard taper known as
Options- A. Morse taper
- B. Seller's taper
- C. Chapman taper
- D. Brown and Sharpe taper
- Correct Answer
- Morse taper
- 1. Discontinuous chips are formed during machining of
Options- A. brittle metals
- B. ductile metals
- C. hard metals
- D. soft metals Discuss
- 2. In a planer
Options- A. tool is stationary and work reciprocates
- B. work is stationary and tool reciprocates
- C. tool moves over stationary work
- D. tool moves over reciprocating work Discuss
- 3. The floating position of the holding fixture in a rotary transfer device is used to
Options- A. improve the accuracy of location
- B. reduce the tendency to over-index
- C. improve upon the acceleration and deceleration characteristics
- D. reduce the cycle time Discuss
- 4. A round nose tool has no back rake and side rake.
Options- A. Correct
- B. Incorrect Discuss
- 5. In a plain milling cutter, the portion of the gash adjacent to the cutting edge on which the chip impinges is called
Options- A. face
- B. fillet
- C. land
- D. lead Discuss
- 6. The operation of smoothing and squaring the surface around a hole is known as
Options- A. counter-sinking
- B. counter-boring
- C. trepanning
- D. spot facing Discuss
- 7. In metal cutting operations, the shear angle is the angle made by the shear plane with the
Options- A. direction of the tool axis
- B. direction of tool travel
- C. perpendicular to the direction of the tool axis
- D. central plane of the workpiece Discuss
- 8. An operation of enlarging the end of a hole cylindrically is known as grooving.
Options- A. Correct
- B. Incorrect Discuss
- 9. Which of the following statement is wrong as regard to down milling?
Options- A. It can not be used on old machines due to backlash between the feed screw of the table and the nut.
- B. The chips are disposed off easily and do not interfere with the cutting.
- C. The surface milled appears to be slightly wavy.
- D. The coolant can be poured directly at the cutting zone where the cutting force is maximum. Discuss
- 10. The infeed grinding is similar to plunge grinding.
Options- A. Yes
- B. No Discuss
Production Engineering problems
Search Results
Correct Answer: brittle metals
Correct Answer: tool is stationary and work reciprocates
Correct Answer: reduce the cycle time
Correct Answer: Correct
Correct Answer: face
Correct Answer: spot facing
Correct Answer: direction of tool travel
Correct Answer: Incorrect
Correct Answer: The surface milled appears to be slightly wavy.
Correct Answer: Yes
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.