Discussion
Home ‣ Mechanical Engineering ‣ Production Engineering Comments
- Question
The structure of a grinding wheel depends upon
Options- A. hardness of the material being ground
- B. nature of the grinding operation
- C. finish required
- D. all of these
- Correct Answer
- all of these
- 1. The obtuse angle, included between the chisel edge and the lip as viewed from the end of a drill, is called
Options- A. helix or rake angle
- B. point angle
- C. chisel edge angle
- D. lip clearance angle Discuss
- 2. When the metal is removed by erosion caused by rapidly recurring spark discharges between the tool and work, the process is known as
Options- A. electro-chemical machining
- B. electro-discharge machining
- C. ultra-sonic machining
- D. none of these Discuss
- 3. The plain milling machine is more rigid and heavier in construction than a universal milling machine of the same size.
Options- A. Correct
- B. Incorrect Discuss
- 4. The cutting speed is zero at the periphery and it is maximum at the centre of the drill.
Options- A. Yes
- B. No Discuss
- 5. In electro-discharge machining, dielectric is used to
Options- A. help in the movement of the sparks
- B. control the spark discharges
- C. act as coolant
- D. all of these Discuss
- 6. The ductile materials, during machining, produce
Options- A. continuous chips
- B. discontinuous chips
- C. continuous chips with built up edge
- D. either (a) or (c) Discuss
- 7. It is desired to perform the operations like drilling, reaming, counter-boring etc. on a work piece. Which of the following machine will be used?
Options- A. Sensitive drilling machine
- B. Radial drilling machine
- C. Gang drilling machine
- D. Multiple spindle drilling machine Discuss
- 8. An operation of embossing a diamond shaped pattern on the surface of a workpiece, is known as
Options- A. counter-boring
- B. grooving
- C. knurling
- D. facing Discuss
- 9. In a plain milling cutter, the chip space between the back of one tooth and the face of the next tooth is called
Options- A. face
- B. fillet
- C. gash
- D. land Discuss
- 10. Tool signature consists of __________ elements.
Options- A. two
- B. four
- C. five
- D. seven Discuss
Production Engineering problems
Search Results
Correct Answer: chisel edge angle
Correct Answer: electro-discharge machining
Correct Answer: Correct
Correct Answer: No
Correct Answer: all of these
Correct Answer: either (a) or (c)
Correct Answer: Gang drilling machine
Correct Answer: knurling
Correct Answer: gash
Correct Answer: seven
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.