Discussion
Home ‣ Mechanical Engineering ‣ Production Engineering Comments
- Question
A drill mainly used in drilling brass, copper or softer materials, is
Options- A. flat drill
- B. straight fluted drill
- C. parallel shank twist drill
- D. tapered shank twist drill
- Correct Answer
- straight fluted drill
- 1. The size of a lathe is specified by the
Options- A. length between centres
- B. swing diameter over the bed
- C. swing diameter over the carriage
- D. all of these Discuss
- 2. Dielectric is used in
Options- A. electro-chemical machining
- B. ultra-sonic machining
- C. electro-discharge machining
- D. laser machining Discuss
- 3. The hole to be drilled for tapping is __________ the outside diameter of the thread on the tap.
Options- A. equal to
- B. smaller than
- C. greater than Discuss
- 4. Jigs are used
Options- A. for holding and guiding the tool in drilling, reaming or tapping operations
- B. for holding the work in milling, grinding, planing or turning operations
- C. to check the accuracy of workpiece
- D. none of the above Discuss
- 5. Gears can be cut on a shaper.
Options- A. Agree
- B. Disagree Discuss
- 6. Flank wear occurs mainly on the
Options- A. nose part, front relief face and side relief face of the cutting tool
- B. face of the cutting tool at a short distance from the cutting edge
- C. cutting edge only
- D. front face only Discuss
- 7. The hole drilled for tapping should be smaller than the tap size by twice the depth of thread.
Options- A. Agree
- B. Disagree Discuss
- 8. Which of the following statement is wrong?
Options- A. The larger side rake angle produces chipping.
- B. The smaller rake angle produces excessive wear and deformation in tool.
- C. The side cutting edge angle (less than 15°) increases tool life.
- D. The increase in nose radius decreases tool life. Discuss
- 9. Slow speed of the spindle is necessary in
Options- A. thread cutting
- B. turning a work of larger diameter
- C. turning a hard or tough material
- D. all of these Discuss
- 10. The tool life is affected by
Options- A. depth of cut
- B. cutting speed
- C. feed
- D. all of these Discuss
Production Engineering problems
Search Results
Correct Answer: all of these
Correct Answer: electro-discharge machining
Correct Answer: smaller than
Correct Answer: for holding and guiding the tool in drilling, reaming or tapping operations
Correct Answer: Agree
Correct Answer: nose part, front relief face and side relief face of the cutting tool
Correct Answer: Agree
Correct Answer: The increase in nose radius decreases tool life.
Correct Answer: all of these
Correct Answer: all of these
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.