Discussion
Home ‣ Mechanical Engineering ‣ Production Engineering Comments
- Question
Jigs are used
Options- A. for holding and guiding the tool in drilling, reaming or tapping operations
- B. for holding the work in milling, grinding, planing or turning operations
- C. to check the accuracy of workpiece
- D. none of the above
- Correct Answer
- for holding and guiding the tool in drilling, reaming or tapping operations
- 1. Gears can be cut on a shaper.
Options- A. Agree
- B. Disagree Discuss
- 2. Gears can be best produced on mass production by
Options- A. shaping
- B. casting
- C. forming
- D. hobbing Discuss
- 3. In a single point turning operation with a cemented carbide and steel combination having a Taylor exponent of 0.25, if the cutting speed is halved, then tool life will become
Options- A. half
- B. two times
- C. eight times
- D. sixteen times Discuss
- 4. The actual feed in centreless grinders is given by (where d = Dia. of regulating wheel, n = Revolutions per minute, and ? = Angle of inclination of wheel)
Options- A. ?d
- B. ?d n
- C. ?d n sin ?
- D. ?d n cos ? Discuss
- 5. To grind brittle materials, a coarse grained grinding wheel is used.
Options- A. Agree
- B. Disagree Discuss
- 6. The hole to be drilled for tapping is __________ the outside diameter of the thread on the tap.
Options- A. equal to
- B. smaller than
- C. greater than Discuss
- 7. Dielectric is used in
Options- A. electro-chemical machining
- B. ultra-sonic machining
- C. electro-discharge machining
- D. laser machining Discuss
- 8. The size of a lathe is specified by the
Options- A. length between centres
- B. swing diameter over the bed
- C. swing diameter over the carriage
- D. all of these Discuss
- 9. A drill mainly used in drilling brass, copper or softer materials, is
Options- A. flat drill
- B. straight fluted drill
- C. parallel shank twist drill
- D. tapered shank twist drill Discuss
- 10. Flank wear occurs mainly on the
Options- A. nose part, front relief face and side relief face of the cutting tool
- B. face of the cutting tool at a short distance from the cutting edge
- C. cutting edge only
- D. front face only Discuss
Production Engineering problems
Search Results
Correct Answer: Agree
Correct Answer: hobbing
Correct Answer: sixteen times
Correct Answer: ?d n sin ?
Correct Answer: Disagree
Correct Answer: smaller than
Correct Answer: electro-discharge machining
Correct Answer: all of these
Correct Answer: straight fluted drill
Correct Answer: nose part, front relief face and side relief face of the cutting tool
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.