Discussion
Home ‣ Mechanical Engineering ‣ Production Engineering Comments
- Question
A dynamometer is a device used for the measurement of
Options- A. chip thickness ratio
- B. forces during metal cutting
- C. wear of the cutting tool
- D. deflection of the cutting tool
- Correct Answer
- forces during metal cutting
- 1. A grinding wheel is said to be of __________ if it holds the abrasive grains more securely.
Options- A. soft grade
- B. medium grade
- C. hard grade Discuss
- 2. Glazing in grinding wheels takes place when the
Options- A. wheel is too hard or wheel revolves at a very high speed
- B. wheel is too soft or wheel revolves at a very slow speed
- C. wheel is too hard and wheel revolves at very slow speed
- D. wheel is too soft and wheel revolves at a very high speed Discuss
- 3. A jig is defined as a device which
Options- A. holds and locates a workpiece and guides and controls one or more cutting tools
- B. holds and locates a workpiece during an inspection or for a manufacturing operation
- C. is used to check the accuracy of workpiece
- D. all of the above Discuss
- 4. The factor responsible for the formation of discontinuous chips is
Options- A. low cutting speed and large rake angle
- B. low cutting speed and small rake angle
- C. high cutting speed and large rake angle
- D. high cutting speed and small rake angle Discuss
- 5. The keyways, grooves and slots cannot be cut on a shaper.
Options- A. True
- B. False Discuss
- 6. The cutting speed of a drill depends upon the
Options- A. material of drill
- B. type of material to be drilled
- C. quality of surface finish desired
- D. all of these Discuss
- 7. Which of the following process is used for preparing parts having large curved surfaces and thin sections?
Options- A. Hot machining
- B. Ultra-sonic machining
- C. ECM process
- D. Chemical milling Discuss
- 8. A mandrel is used to hold
Options- A. an eccentric work
- B. a heavy work
- C. a thin work
- D. none of these Discuss
- 9. In drilling operation, the metal is removed by
Options- A. shearing
- B. extrusion
- C. shearing and extrusion
- D. shearing and compression Discuss
- 10. A 15 mm drilling machine means that it can drill a hole
Options- A. ofmaximumdiameter 15 mm
- B. in 15 mm thick plates
- C. having cross-sectional area of 15 mm2
- D. none of these Discuss
Production Engineering problems
Search Results
Correct Answer: hard grade
Correct Answer: wheel is too hard or wheel revolves at a very high speed
Correct Answer: holds and locates a workpiece and guides and controls one or more cutting tools
Correct Answer: low cutting speed and small rake angle
Correct Answer: False
Correct Answer: all of these
Correct Answer: Chemical milling
Correct Answer: none of these
Correct Answer: shearing and extrusion
Correct Answer: ofmaximumdiameter 15 mm
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.