Discussion
Home ‣ Mechanical Engineering ‣ Production Engineering Comments
- Question
The cutting speed of a drill varies from point to point on the cutting edge of the drill.
Options- A. Correct
- B. Incorrect
- Correct Answer
- Correct
- 1. The helix angle of a drill is __________ for drilling brass.
Options- A. equal to 30°
- B. less than 30°
- C. more than 30° Discuss
- 2. The grinding operaion is a
Options- A. shaping operation
- B. forming operation
- C. surface finishing operation
- D. dressing operation Discuss
- 3. In continuous chip cutting, the maximum heat __________ the velocity of cutting.
Options- A. depends upon
- B. does not depend upon Discuss
- 4. Gear burnishing is a process for
Options- A. surface finishing
- B. under-cut gears
- C. cycloidal gears
- D. removing residual stresses from teeth roots Discuss
- 5. The high cutting speed and large rake angle of the tool will result in the formation of
Options- A. continuous chips
- B. discontinuous chip
- C. continuous chips with built up edge
- D. none of these Discuss
- 6. The cutting force in up milling __________ per tooth movement of the cutter.
Options- A. is zero
- B. is maximum
- C. decreases from maximum to zero
- D. increases from zero to maximum Discuss
- 7. Which of the following operations is carried out at a minimum cutting velocity if the machines are equally rigid and the tool work materials are the same?
Options- A. Turning
- B. Grinding
- C. Boring
- D. Milling Discuss
- 8. The height of each tooth of a broach is
Options- A. same throughout
- B. in progressively decreasing order
- C. in progressively increasing order
- D. none of these Discuss
- 9. High speed steel tools retain their hardness upto a temperature of
Options- A. 250°C
- B. 350°C
- C. 500°C
- D. 900°C Discuss
- 10. In hot machining, solid carbide tools are preferred over high speed steel tools.
Options- A. True
- B. False Discuss
Production Engineering problems
Search Results
Correct Answer: less than 30°
Correct Answer: surface finishing operation
Correct Answer: depends upon
Correct Answer: surface finishing
Correct Answer: continuous chips
Correct Answer: increases from zero to maximum
Correct Answer: Milling
Correct Answer: in progressively increasing order
Correct Answer: 900°C
Correct Answer: True
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.