Discussion
Home ‣ Mechanical Engineering ‣ Production Engineering Comments
- Question
A set of eight form relieved milling cutters for each module is provided to enable cutting of gears of different
Options- A. materials
- B. types of gears
- C. number of teeth
- D. width of gears
- Correct Answer
- number of teeth
- 1. In centreless grinders, the maximum angular adjustment of the regulating wheel is
Options- A. 5°
- B. 10°
- C. 15°
- D. 20° Discuss
- 2. Which of the following statement is wrong?
Options- A. The diamond is the hardest tool material and can run at cutting speeds about 50 times that of high speed steel tool.
- B. The ceramic tools can be used at cutting speeds 40 times that of high speed steel tools.
- C. The cemented carbide tools can be used at cutting speeds 10 times that of high speed steel tools.
- D. The ceramic tools can withstand temperature upto 600°C only. Discuss
- 3. In a single point tool, the angle between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base, is known as
Options- A. side relief angle
- B. end relief angle
- C. back rake angle
- D. side rake angle Discuss
- 4. Cutting fluid has no effect on the tool life.
Options- A. True
- B. False Discuss
- 5. The type of reamer used for reaming operation in a blind hole, is
Options- A. straight fluted reamer
- B. left hand spiral fluted reamer
- C. right hand spiral fluted reamer
- D. any one of these Discuss
- 6. The snag grinding is done
Options- A. to produce good surface finish and high degree of accuracy
- B. to remove considerable amount of metal without regard to accuracy of the finished surface
- C. to grind exterior cylindrical surfaces
- D. any one of the above Discuss
- 7. The soft grade grinding wheels are denoted by the letters
Options- A. A to H
- B. I to P
- C. Q to Z
- D. A to P Discuss
- 8. In oblique cutting system, the maximum chip thickness
Options- A. occurs at the middle
- B. may not occur at the middle
- C. depends upon the material of the tool
- D. depends upon the geometry of the tool Discuss
- 9. The guideways are of
Options- A. flat type
- B. V-type
- C. dovetail type
- D. any one of these Discuss
- 10. High speed steel cutting tools operate at cutting speeds __________ than carbon steel tools.
Options- A. 2 to 3 times lower
- B. 2 to 3 times higher
- C. 5 to 8 times higher
- D. 8 to 20 times higher Discuss
Production Engineering problems
Search Results
Correct Answer: 10°
Correct Answer: The ceramic tools can withstand temperature upto 600°C only.
Correct Answer: end relief angle
Correct Answer: False
Correct Answer: right hand spiral fluted reamer
Correct Answer: to remove considerable amount of metal without regard to accuracy of the finished surface
Correct Answer: A to H
Correct Answer: may not occur at the middle
Correct Answer: any one of these
Correct Answer: 2 to 3 times higher
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.