Discussion
Home ‣ Mechanical Engineering ‣ Production Engineering Comments
- Question
Which of the following statement is wrong?
Options- A. The diamond is the hardest tool material and can run at cutting speeds about 50 times that of high speed steel tool.
- B. The ceramic tools can be used at cutting speeds 40 times that of high speed steel tools.
- C. The cemented carbide tools can be used at cutting speeds 10 times that of high speed steel tools.
- D. The ceramic tools can withstand temperature upto 600°C only.
- Correct Answer
- The ceramic tools can withstand temperature upto 600°C only.
- 1. In a single point tool, the angle between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base, is known as
Options- A. side relief angle
- B. end relief angle
- C. back rake angle
- D. side rake angle Discuss
- 2. Cutting fluid has no effect on the tool life.
Options- A. True
- B. False Discuss
- 3. The type of reamer used for reaming operation in a blind hole, is
Options- A. straight fluted reamer
- B. left hand spiral fluted reamer
- C. right hand spiral fluted reamer
- D. any one of these Discuss
- 4. The size of a shaper is given by
Options- A. stroke length
- B. motor power
- C. mass of machine
- D. rate size Discuss
- 5. The trade name of a non-ferrous cast alloy composed of cobalt, chromium and tungsten is called
Options- A. ceramic
- B. stellite
- C. diamond
- D. cemented carbide Discuss
- 6. In centreless grinders, the maximum angular adjustment of the regulating wheel is
Options- A. 5°
- B. 10°
- C. 15°
- D. 20° Discuss
- 7. A set of eight form relieved milling cutters for each module is provided to enable cutting of gears of different
Options- A. materials
- B. types of gears
- C. number of teeth
- D. width of gears Discuss
- 8. The snag grinding is done
Options- A. to produce good surface finish and high degree of accuracy
- B. to remove considerable amount of metal without regard to accuracy of the finished surface
- C. to grind exterior cylindrical surfaces
- D. any one of the above Discuss
- 9. The soft grade grinding wheels are denoted by the letters
Options- A. A to H
- B. I to P
- C. Q to Z
- D. A to P Discuss
- 10. In oblique cutting system, the maximum chip thickness
Options- A. occurs at the middle
- B. may not occur at the middle
- C. depends upon the material of the tool
- D. depends upon the geometry of the tool Discuss
Production Engineering problems
Search Results
Correct Answer: end relief angle
Correct Answer: False
Correct Answer: right hand spiral fluted reamer
Correct Answer: stroke length
Correct Answer: stellite
Correct Answer: 10°
Correct Answer: number of teeth
Correct Answer: to remove considerable amount of metal without regard to accuracy of the finished surface
Correct Answer: A to H
Correct Answer: may not occur at the middle
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.