Discussion
Home ‣ Mechanical Engineering ‣ Production Engineering Comments
- Question
In continuous chip cutting, the maximum heat is taken by the cutting tool.
Options- A. Yes
- B. No
- Correct Answer
- No
- 1. In machining metals, chips break due to __________ of work material.
Options- A. toughness
- B. ductility
- C. elasticity
- D. work hardening Discuss
- 2. Back rake angle of a single point tool is the angle by which the face of the tool is inclined towards back.
Options- A. Agree
- B. Disagree Discuss
- 3. Which of the following operations can be performed with milling cutters?
Options- A. cutting key ways on shafts
- B. cutting external screw threads
- C. cutting teeth of spur gears
- D. all of these Discuss
- 4. Down milling is also called
Options- A. conventional milling
- B. climb milling
- C. end milling
- D. face milling Discuss
- 5. Threading is an operation of
Options- A. smoothing and squaring the surface around a hole
- B. sizing and finishing a small diameter hole
- C. producing a hole by removing metal along the circumference of a hollow cutting tool
- D. cutting helical grooves on the external cylindrical surface Discuss
- 6. The depth of cut in drilling is __________ the drill diameter.
Options- A. equal to
- B. one-fourth
- C. one-half
- D. double Discuss
- 7. When the backgear is engaged in a backgeared headstock, the spindle speed reduces considerably.
Options- A. Agree
- B. Disagree Discuss
- 8. High speed steel drills can be operated at about __________ the speed of high carbon steel drills.
Options- A. one-half
- B. one-fourth
- C. double
- D. four times Discuss
- 9. A process of removing metal by pushing or pulling a cutting tool is called
Options- A. up milling
- B. down milling
- C. forming
- D. broaching Discuss
- 10. In metal machining, the work-tool contact zone is a zone where heat is generated due to
Options- A. plastic deformation of metal
- B. burnishing friction
- C. friction between the moving chip and the tool face
- D. none of the above Discuss
Production Engineering problems
Search Results
Correct Answer: work hardening
Correct Answer: Agree
Correct Answer: all of these
Correct Answer: climb milling
Correct Answer: cutting helical grooves on the external cylindrical surface
Correct Answer: one-half
Correct Answer: Agree
Correct Answer: double
Correct Answer: broaching
Correct Answer: burnishing friction
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.