Discussion
Home ‣ Mechanical Engineering ‣ Production Engineering Comments
- Question
The swing diameter over the bed is __________ the height of the centre measured from the bed of the lathe.
Options- A. equal to
- B. twice
- C. thrice
- D. one-half
- Correct Answer
- twice
- 1. The top and sides of the table of a shaper usually have
Options- A. L-type slots
- B. T-type slots
- C. I-type slots
- D. any one of these Discuss
- 2. Crater wear is predominant in
Options- A. carbon tool steels
- B. tungsten carbide tools
- C. high speed steel tools
- D. ceramic tools Discuss
- 3. As the cutting speed increases, tool life decreases.
Options- A. Yes
- B. No Discuss
- 4. An important geometrical quantity in the cutting of metals which can be used as a criterion for machinability of metals is
Options- A. cutting speed
- B. feed rate
- C. shear angle
- D. tool geometry Discuss
- 5. Thread grinding requires work speed from
Options- A. 1 to 3 m/min
- B. 5 to 10 m/min
- C. 10 to 14 m/min
- D. 14 to 20 m/min Discuss
- 6. The abrasive recommended for grinding materials of high tensile strength is
Options- A. silicon carbide
- B. aluminium oxide
- C. sand stone
- D. diamond Discuss
- 7. Glazing in grinding wheels can be decreased by
Options- A. using a harder wheel or by increasing the wheel speed
- B. using a softer wheel or by decreasing the wheel speed
- C. using a harder wheel or by decreasing the wheel speed
- D. using a softer wheel or by increasing the wheel speed Discuss
- 8. Threading is an operation of
Options- A. smoothing and squaring the surface around a hole
- B. sizing and finishing a small diameter hole
- C. producing a hole by removing metal along the circumference of a hollow cutting tool
- D. cutting helical grooves on the external cylindrical surface Discuss
- 9. Down milling is also called
Options- A. conventional milling
- B. climb milling
- C. end milling
- D. face milling Discuss
- 10. Which of the following operations can be performed with milling cutters?
Options- A. cutting key ways on shafts
- B. cutting external screw threads
- C. cutting teeth of spur gears
- D. all of these Discuss
Production Engineering problems
Search Results
Correct Answer: T-type slots
Correct Answer: tungsten carbide tools
Correct Answer: Yes
Correct Answer: shear angle
Correct Answer: 1 to 3 m/min
Correct Answer: aluminium oxide
Correct Answer: using a softer wheel or by decreasing the wheel speed
Correct Answer: cutting helical grooves on the external cylindrical surface
Correct Answer: climb milling
Correct Answer: all of these
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.