logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Heat Transfer, Refrigeration and Air Conditioning Comments

  • Question
  • Sensible heat factor is given by (where S.H. = Sensible heat, and L.H. = Latent heat)


  • Options
  • A. Sensible heat factor is given by (where S.H. = Sensible heat, and L.H. = Latent heat)
  • B. Sensible heat factor is given by (where S.H. = Sensible heat, and L.H. = Latent heat)
  • C. Sensible heat factor is given by (where S.H. = Sensible heat, and L.H. = Latent heat)
  • D. Sensible heat factor is given by (where S.H. = Sensible heat, and L.H. = Latent heat)

  • Correct Answer
  •  


  • Heat Transfer, Refrigeration and Air Conditioning problems


    Search Results


    • 1. The wet bulb temperature at 100% relative humidity is __________ dry bulb temperature.

    • Options
    • A. same as
    • B. lower than
    • C. higher than
    • Discuss
    • 2. In case of sensible heating of air, the coil efficiency is given by (where B.P.F. = By-pass factor)

    • Options
    • A. B.P.F. - 1
    • B. 1 - B.P.F.
    • C.
    • D. 1 + B.RF.
    • Discuss
    • 3. The coefficient of performance of vapour compression refrigeration system is quite __________ as compared to air refrigeration system.

    • Options
    • A. low
    • B. high
    • Discuss
    • 4. Wein's law states that the wave length corresponding to __________ is proportional to the absolute temperature.

    • Options
    • A. minimum energy
    • B. maximum energy
    • Discuss
    • 5. During sensible cooling of air, the relative humidity increases.

    • Options
    • A. Yes
    • B. No
    • Discuss
    • 6. The horizontal and non-uniformly spaced lines on a psychrometric chart indicates

    • Options
    • A. dry bulb temperature
    • B. wet bulb temperature
    • C. dew point temperature
    • D. specific humidity
    • Discuss
    • 7. In order to cool and dehumidify a stream of moist air, it must be passed over the coil at a temperature

    • Options
    • A. which lies between the dry bulb and wet bulb temperatures of the incoming stream
    • B. which lies between the wet bulb and dew point temperatures of the incoming stream
    • C. which is lower than the dew point temperature of the incoming stream
    • D. of adiabatic saturation of incoming stream
    • Discuss
    • 8. Which of the following refrigerant is highly toxic and flammable?

    • Options
    • A. Ammonia
    • B. Carbon dioxide
    • C. Sulphur dioxide
    • D. R-12
    • Discuss
    • 9. The most commonly used method for the design of duct size is the

    • Options
    • A. velocity reduction method
    • B. equal friction method
    • C. static regain method
    • D. dual or double method
    • Discuss
    • 10. The undesireable property of a refrigerant is

    • Options
    • A. non-toxic
    • B. non-flammable
    • C. non-explosive
    • D. high boiling point
    • Discuss


    Comments

    There are no comments.

Enter a new Comment