Discussion
Home ‣ Mechanical Engineering ‣ Compressors, Gas Dynamics and Gas Turbines Comments
- Question
The overall thermal efficiency of an ideal gas turbine plant is (where r = Pressure ratio)
Options- A. r? - 1
- B. 1 - r? - 1
- C.
- D.
- Correct Answer
-
- 1. A compressor must be driven by some prime mover.
Options- A. Agree
- B. Disagree Discuss
- 2. The gas in cooling chamber of a closed cycle gas turbine is cooled at
Options- A. constant volume
- B. constant temperature
- C. constant pressure
- D. none of these Discuss
- 3. The volumetric efficiency of the compressor is defined as the ratio of volume of free air delivery per stroke to the swept volume of the piston.
Options- A. Yes
- B. No Discuss
- 4. In a single stage, single acting reciprocating air compressor, without clearance volume, the workdone is minimum during
Options- A. isothermal compression
- B. isentropic compression
- C. polytropic compression
- D. none of these Discuss
- 5. The overall isothermal efficiency of the compressor is defined as the ratio of
Options- A. work required to compress the air isothermally to the actual work required to compress the air for the same pressure ratio
- B. isothermal power to the shaft power or B.P. of the motor or engine required to drive the compressor
- C. volume of free air delivery per stroke to the swept volume of the piston
- D. isentropic power to the power required to drive the compressor Discuss
- 6. In air compressors, free air delivery means the
Options- A. actual volume of the air delivered by the compressor when reduced to normal temperature and pressure conditions
- B. volume of air delivered by the compressor
- C. volume of air sucked by the compressor during its suction stroke
- D. none of the above Discuss
- 7. Volumetric efficiency of a compressor decreases with __________ in compression ratio.
Options- A. decrease
- B. increase Discuss
- 8. Which of the following statement is correct?
Options- A. The reciprocating compressors are best suited for high pressure and low volume capacity
- B. The effect of clearance volume on power consumption is negligible for the same volume of discharge
- C. both (a) and (b)
- D. none of these Discuss
- 9. If the flow of air through the compressor is parallel to its axis, then the compressor is
Options- A. reciprocating compressor
- B. centrifugal compressor
- C. axial flow compressor
- D. turbo-compressor Discuss
- 10. For minimum work required to compress and deliver a quantity of air by multi-stage compression,
Options- A. the compression ratio in each stage should be same
- B. the intercooling should be perfect
- C. the workdone in each stage should be same
- D. all of the above Discuss
Compressors, Gas Dynamics and Gas Turbines problems
Search Results
Correct Answer: Agree
Correct Answer: constant pressure
Correct Answer: Yes
Correct Answer: isothermal compression
Correct Answer: isothermal power to the shaft power or B.P. of the motor or engine required to drive the compressor
Correct Answer: actual volume of the air delivered by the compressor when reduced to normal temperature and pressure conditions
Correct Answer: increase
Correct Answer: both (a) and (b)
Correct Answer: axial flow compressor
Correct Answer: all of the above
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.