Discussion
Home ‣ Mechanical Engineering ‣ Compressors, Gas Dynamics and Gas Turbines Comments
- Question
With the decrease in compression ratio, the volumetric efficiency
Options- A. does not change
- B. increases
- C. decreases
- Correct Answer
- increases
- 1. The thrust of a jet propulsion power unit can be increased by
Options- A. injecting water into the compressor
- B. burning fuel after gas turbine
- C. injecting ammonia into the combustion chamber
- D. all of the above Discuss
- 2. The compression ratio for the compressor is always __________ unity.
Options- A. equal to
- B. less than
- C. more than Discuss
- 3. Slip factor in a centrifugal compressor indicates the amount of air leaked from the storage vessel.
Options- A. Yes
- B. No Discuss
- 4. A 3 m3/min compressor means that it
Options- A. compresses 3 m3/min of standard air
- B. compresses 3 m3/ min of free air
- C. delivers 3 m3/ min of compressed air
- D. delivers 3 m3/ min of compressed air at delivery pressure Discuss
- 5. The reason for volumetric efficiency of reciprocating compressor being less than 100 percent is
Options- A. pressure drop across the valves
- B. superheating in compressor
- C. clearance volume and leakages
- D. all of these Discuss
- 6. The overall isothermal efficiency of the compressor is defined as the ratio of
Options- A. work required to compress the air isothermally to the actual work required to compress the air for the same pressure ratio
- B. isothermal power to the shaft power or B.P. of the motor or engine required to drive the compressor
- C. volume of free air delivery per stroke to the swept volume of the piston
- D. isentropic power to the power required to drive the compressor Discuss
- 7. In a single stage, single acting reciprocating air compressor, without clearance volume, the workdone is minimum during
Options- A. isothermal compression
- B. isentropic compression
- C. polytropic compression
- D. none of these Discuss
- 8. The volumetric efficiency of the compressor is defined as the ratio of volume of free air delivery per stroke to the swept volume of the piston.
Options- A. Yes
- B. No Discuss
- 9. The gas in cooling chamber of a closed cycle gas turbine is cooled at
Options- A. constant volume
- B. constant temperature
- C. constant pressure
- D. none of these Discuss
- 10. A compressor must be driven by some prime mover.
Options- A. Agree
- B. Disagree Discuss
Compressors, Gas Dynamics and Gas Turbines problems
Search Results
Correct Answer: all of the above
Correct Answer: more than
Correct Answer: No
Correct Answer: compresses 3 m3/ min of free air
Correct Answer: all of these
Correct Answer: isothermal power to the shaft power or B.P. of the motor or engine required to drive the compressor
Correct Answer: isothermal compression
Correct Answer: Yes
Correct Answer: constant pressure
Correct Answer: Agree
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.