Discussion
Home ‣ Mechanical Engineering ‣ Compressors, Gas Dynamics and Gas Turbines Comments
- Question
For maximum work, the reheating should be done to an intermediate pressure of (where p1 = Maximum pressure, and p2 = Minimum pressure)
Options- A.
- B.
- C.
- D. p1p2
- Correct Answer
- p1p2
- 1. Free air is the air at atmospheric conditions at any specific location.
Options- A. True
- B. False Discuss
- 2. In a centrifugal compressor, the ratio of the __________ to the blade velocity is called slip factor.
Options- A. inlet whirl velocity
- B. outlet whirl velocity
- C. inlet velocity of flow
- D. outlet velocity of flow Discuss
- 3. The overall efficiency of the compressed air system is the
Options- A. ratio of shaft output of the air motor to the shaft input to the compressor
- B. ratio of shaft input to the compressor to the shaft output of air motor
- C. product of shaft output of air motor and shaft input to the compressor
- D. none of the above Discuss
- 4. The temperature of air at the beginning of the compression stroke is __________ the atmospheric temperature.
Options- A. equal to
- B. less than
- C. more than Discuss
- 5. Euler's equation can be used for
Options- A. radial flow compressors
- B. axial flow compressors
- C. pumps
- D. all of these Discuss
- 6. Which of the following statement is correct relating to rocket engines?
Options- A. The combustion chamber in a rocket engine is directly analogous to the reservoir of a super sonic wind tunnel
- B. The stagnation conditions exist at the combustion chamber
- C. The exit velocities of exhaust gases are much higher than those in jet engine
- D. all of the above Discuss
- 7. In a single stage, single acting reciprocating air compressor, without clearance, the workdone on the air during isentropic compression is __________ the heat required to raise the temperature of air from T1 to T2 at a constant pressure.
Options- A. equal to
- B. less than
- C. greater than Discuss
- 8. The pressure of air at the beginning of the compression stroke is __________ the atmospheric pressure.
Options- A. equal to
- B. less than
- C. more than Discuss
- 9. The process, which causes the air to enter the impeller blades of a centrifugal compressor at __________ velocity (without effecting the mass of air to flow and velocity of flow) is known as prewhirl.
Options- A. reduced
- B. increased Discuss
- 10. The axial flow compressor is preferred in air-craft gas turbines because of
Options- A. low frontal area
- B. higher thrust
- C. high pressure rise
- D. none of these Discuss
Compressors, Gas Dynamics and Gas Turbines problems
Search Results
Correct Answer: True
Correct Answer: outlet velocity of flow
Correct Answer: ratio of shaft output of the air motor to the shaft input to the compressor
Correct Answer: more than
Correct Answer: all of these
Correct Answer: all of the above
Correct Answer: equal to
Correct Answer: less than
Correct Answer: reduced
Correct Answer: low frontal area
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.