Discussion
Home ‣ Mechanical Engineering ‣ IC Engines and Nuclear Power Plants Comments
- Question
In diesel engines, the ignition takes place due to the heat produced in the engine cylinder at the end of compression.
Options- A. Correct
- B. Incorrect
- Correct Answer
- Correct
- 1. A nuclear reactor is said to be critical when the neutron population in the reactor core is
Options- A. rapidly increasing leading to the point of explosion
- B. decreasing from the specified value
- C. reduced to zero
- D. constant Discuss
- 2. The ignition of the charge by some hot surface within the engine before the passage of spark is called
Options- A. pre-ignition
- B. detonation
- C. ignition delay
- D. auto-ignition Discuss
- 3. If the compression ratio in I.C. engine increases, then its thermal efficiency will
Options- A. decrease
- B. increase
- C. remain same Discuss
- 4. Which of the following statement is correct regarding the features of a Breeder reactor?
Options- A. It produces more fuel than it consumes.
- B. It requires highly enriched fuel.
- C. It requires liquid sodium metal as moderator.
- D. all of the above Discuss
- 5. The brake power is the power available
Options- A. in the engine cylinder
- B. at the crank shaft
- C. at the crank pin
- D. none of these Discuss
- 6. A power plant giving least running cost of production of electrical power is
Options- A. steam power plant
- B. gas turbine power plant
- C. hydro electric power plant
- D. nuclear power plant Discuss
- 7. The loud pulsating noise heard within the cylinder of an internal combustion engine is known as
Options- A. detonation
- B. turbulence
- C. pre-ignition
- D. supercharging Discuss
- 8. The slowing down of fast neutrons is desirable because slow moving neutrons are more effective than fast neutrons in triggering fission.
Options- A. Agree
- B. Disagree Discuss
- 9. The brake power (B.P.) of the engine is given by (where W = Brake load or dead load in newtons, l = Length of arm in metres, N = Speed of engine in r.p.m., S - Spring balance reading in newtons, D = Dia. of brake drum in metres, and d = Dia. of rope in metres)
Options- A.
- B.
- C.
- D. all of these Discuss
- 10. A supercharged engine as compared to an ordinary engine
Options- A. is lighter
- B. requires smaller foundations
- C. consumes less lubricating oil
- D. all of these Discuss
IC Engines and Nuclear Power Plants problems
Search Results
Correct Answer: constant
Correct Answer: pre-ignition
Correct Answer: increase
Correct Answer: all of the above
Correct Answer: at the crank shaft
Correct Answer: nuclear power plant
Correct Answer: detonation
Correct Answer: Agree
Correct Answer: all of these
Correct Answer: all of these
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.