Discussion
Home ‣ Mechanical Engineering ‣ IC Engines and Nuclear Power Plants Comments
- Question
The brake power is the power available
Options- A. in the engine cylinder
- B. at the crank shaft
- C. at the crank pin
- D. none of these
- Correct Answer
- at the crank shaft
- 1. The volumetric efficiency ofa well designed engine may be
Options- A. 30 to 40%
- B. 40 to 60%
- C. 60 to 70%
- D. 75 to 90% Discuss
- 2. A long delay period in compression ignition engines gives a more rapid rise in pressure which causes knocking.
Options- A. Yes
- B. No Discuss
- 3. Detonation is harmful due to
Options- A. increase in the rate of heat transfer, there is a reduction in the power output and efficiency of the engine
- B. excessive turbulence which removes most of the insulating gas boundary layer from the cylinder walls
- C. high intensity of knock causes crankshaft vibration and the engine runs rough
- D. none of the above Discuss
- 4. The knocking in diesel engines may be prevented by
Options- A. reducing the delay period
- B. raising the compression ratio
- C. increasing the inlet pressure of air
- D. all of these Discuss
- 5. The normal heptane (C7H16) is given a rating of __________ octane number.
Options- A. 0
- B. 50
- C. 100
- D. 120 Discuss
- 6. Which of the following statement is correct regarding the features of a Breeder reactor?
Options- A. It produces more fuel than it consumes.
- B. It requires highly enriched fuel.
- C. It requires liquid sodium metal as moderator.
- D. all of the above Discuss
- 7. If the compression ratio in I.C. engine increases, then its thermal efficiency will
Options- A. decrease
- B. increase
- C. remain same Discuss
- 8. The ignition of the charge by some hot surface within the engine before the passage of spark is called
Options- A. pre-ignition
- B. detonation
- C. ignition delay
- D. auto-ignition Discuss
- 9. A nuclear reactor is said to be critical when the neutron population in the reactor core is
Options- A. rapidly increasing leading to the point of explosion
- B. decreasing from the specified value
- C. reduced to zero
- D. constant Discuss
- 10. In diesel engines, the ignition takes place due to the heat produced in the engine cylinder at the end of compression.
Options- A. Correct
- B. Incorrect Discuss
IC Engines and Nuclear Power Plants problems
Search Results
Correct Answer: 75 to 90%
Correct Answer: Yes
Correct Answer: none of the above
Correct Answer: all of these
Correct Answer: 0
Correct Answer: all of the above
Correct Answer: increase
Correct Answer: pre-ignition
Correct Answer: constant
Correct Answer: Correct
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.