Discussion
Home ‣ Mechanical Engineering ‣ IC Engines and Nuclear Power Plants Comments
- Question
The method of determination of indicated power of a multi cylinder spark ignition engine is by the use of
Options- A. Morse test
- B. prony brake test
- C. motoring test
- D. heat balance test
- Correct Answer
- Morse test
- 1. The sensing element in the control system of nuclear reactors measure the __________ of the neutron flux in the reactor.
Options- A. temperature
- B. volume
- C. density
- D. none of these Discuss
- 2. The brake power is always greater than indicated power.
Options- A. Agree
- B. Disagree Discuss
- 3. During idling, a petrol engine requires __________ mixture.
Options- A. lean
- B. rich
- C. chemically correct Discuss
- 4. In a four stroke cycle petrol engine, the expansion
Options- A. starts at top dead centre and ends at bottom dead centre
- B. starts at 30° before top dead centre and ends at 50° before bottom dead centre
- C. starts at 30° after top dead centre and ends at 50° after bottom dead centre
- D. may start and end anywhere Discuss
- 5. If petrol is used in a diesel engine, then
Options- A. low power will be produced
- B. efficiency will be low
- C. higher knocking will occur
- D. black smoke will be produced Discuss
- 6. The first nuclear power plant in India was located at
Options- A. Kota
- B. Tarapur
- C. Bareilly
- D. none of these Discuss
- 7. Which of the following statement is correct regarding normal cetaine?
Options- A. It is a standard fuel used for knock rating of diesel engines.
- B. Its chemical name is normal-hexadecane.
- C. It has long carbon chain structure.
- D. all ofthe above Discuss
- 8. The probability of knocking in diesel engines is increased by
Options- A. high self ignition temperature
- B. low volatility
- C. higher viscosity
- D. all of these Discuss
- 9. Enriched uranium is required as a fuel in a nuclear reactor, if light water is used as moderator and coolant, because light water has
Options- A. high neutron absorption cross-section
- B. low moderating efficiency
- C. high neutron scatter cross-section
- D. low neutron absorption cross-section Discuss
- 10. In an internal combustion engine, the process of removing the burnt gases from the combustion chamber of the engine cylinder is known as
Options- A. scavenging
- B. detonation
- C. supercharging
- D. polymerisation Discuss
IC Engines and Nuclear Power Plants problems
Search Results
Correct Answer: density
Correct Answer: Disagree
Correct Answer: rich
Correct Answer: starts at 30° before top dead centre and ends at 50° before bottom dead centre
Correct Answer: higher knocking will occur
Correct Answer: Tarapur
Correct Answer: all ofthe above
Correct Answer: all of these
Correct Answer: low moderating efficiency
Correct Answer: scavenging
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.