logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering IC Engines and Nuclear Power Plants Comments

  • Question
  • In a four stroke cycle petrol engine, the expansion


  • Options
  • A. starts at top dead centre and ends at bottom dead centre
  • B. starts at 30° before top dead centre and ends at 50° before bottom dead centre
  • C. starts at 30° after top dead centre and ends at 50° after bottom dead centre
  • D. may start and end anywhere

  • Correct Answer
  • starts at 30° before top dead centre and ends at 50° before bottom dead centre 


  • IC Engines and Nuclear Power Plants problems


    Search Results


    • 1. If petrol is used in a diesel engine, then

    • Options
    • A. low power will be produced
    • B. efficiency will be low
    • C. higher knocking will occur
    • D. black smoke will be produced
    • Discuss
    • 2. The ignition quality of diesel oil is expressed by

    • Options
    • A. cetane number
    • B. octane number
    • C. calorific value
    • D. none of these
    • Discuss
    • 3. In petrol engines, using a fixed octane rating fuel, the increase in compression ratio will not effect the knocking tendency.

    • Options
    • A. Agree
    • B. Disagree
    • Discuss
    • 4. Enriched uranium may contain fissionable contents from

    • Options
    • A. 1 to 40%
    • B. 10 to 50%
    • C. 1 to 80%
    • D. 1 to 99%
    • Discuss
    • 5. Diesel as compared to petrol is

    • Options
    • A. highly ignitable
    • B. more difficult to ignite
    • C. less difficult to ignite
    • D. none of these
    • Discuss
    • 6. During idling, a petrol engine requires __________ mixture.

    • Options
    • A. lean
    • B. rich
    • C. chemically correct
    • Discuss
    • 7. The brake power is always greater than indicated power.

    • Options
    • A. Agree
    • B. Disagree
    • Discuss
    • 8. The sensing element in the control system of nuclear reactors measure the __________ of the neutron flux in the reactor.

    • Options
    • A. temperature
    • B. volume
    • C. density
    • D. none of these
    • Discuss
    • 9. The method of determination of indicated power of a multi cylinder spark ignition engine is by the use of

    • Options
    • A. Morse test
    • B. prony brake test
    • C. motoring test
    • D. heat balance test
    • Discuss
    • 10. The first nuclear power plant in India was located at

    • Options
    • A. Kota
    • B. Tarapur
    • C. Bareilly
    • D. none of these
    • Discuss


    Comments

    There are no comments.

Enter a new Comment