logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Steam Nozzles and Turbines Comments

  • Question
  • The effect of friction in the nozzle __________ dryness fraction of steam.


  • Options
  • A. has no effect on
  • B. decreases
  • C. increases

  • Correct Answer
  • increases 


  • Steam Nozzles and Turbines problems


    Search Results


    • 1. The critical pressure ratio is given by (where p1 = Initial pressure of steam, and p2 = Pressure of steam at throat or critical pressure)

    • Options
    • A. p1 p2
    • B. p1/p2
    • C. p2/p1
    • D. p1 + p2
    • Discuss
    • 2. A steam turbine, in which a part of the steam after partial expansion, is used for process heating and the remaining steam is further expanded for power generation, is known as

    • Options
    • A. back pressure turbine
    • B. pass out turbine
    • C. low pressure turbine
    • D. impulse turbine
    • Discuss
    • 3. The maximum efficiency of a De-Laval turbine is (where ? = Nozzle angle)

    • Options
    • A. sin2 ?
    • B. cos2 ?
    • C. tan2 ?
    • D. cot2 ?
    • Discuss
    • 4. Degree of reaction is defined as the ratio of

    • Options
    • A. heat drop in fixed blades to the heat drop in moving blades
    • B. heat drop in moving blades to the heat drop in fixed blades
    • C. heat drop in moving blades to the heat drop in fixed blades plus heat drop in moving blades
    • D. heat drop in fixed blades plus heat drop in moving blades to the heat drop in moving blades
    • Discuss
    • 5. In a reaction turbine when the degree of reaction is zero, then there is

    • Options
    • A. no heat drop in moving blades
    • B. no heat drop in fixed blades
    • C. maximum heat drop in moving blades
    • D. maximum heat drop in fixed blades
    • Discuss
    • 6. In a reaction turbine, when steam flows through the moving blades,

    • Options
    • A. pressure increases while velocity decreases
    • B. pressure decreases while velocity increases
    • C. pressure and velocity both decreases
    • D. pressure and velocity both increases
    • Discuss
    • 7. In turbines, the fluid undergoes a continuous steady flow process and the speed of flow is

    • Options
    • A. low
    • B. very low
    • C. high
    • D. very high
    • Discuss
    • 8. Stage efficiency is also known as

    • Options
    • A. diagram efficiency
    • B. nozzle efficiency
    • C. gross efficiency
    • D. none of these
    • Discuss
    • 9. The correct mixture strength (by weight) for petrol is about

    • Options
    • A. 14.6:1
    • B. 18.5:1
    • C. 20.4:1
    • D. 22.6:1
    • Discuss
    • 10. A petrol engine, during suction stroke draws

    • Options
    • A. air only
    • B. petrol only
    • C. a mixture of petrol and air
    • Discuss


    Comments

    There are no comments.

Enter a new Comment