Discussion
Home ‣ Mechanical Engineering ‣ Thermodynamics See What Others Are Saying!
- Question
The efficiency of a dual combustion cycle __________ upon cut-off ratio.
Options- A. depends
- B. does not depend
- Correct Answer
- depends
- 1. A submerged body is said to be in a stable equilibrium, if its centre of gravity __________ the centre of buoyancy.
Options- A. coincides with
- B. lies below
- C. lies above Discuss
- 2. The function of antilock brake system (ABS) is that is
Options- A. reduces the stopping distance
- B. minimises the brake fade
- C. maintains directional control during braking by preventing the wheels from locking
- D. prevents nose dives during braking and thereby postpones locking of the wheels Discuss
- 3. For evaporators and condensers, for the given conditions, the logarithmic mean temperature difference (tm) for parallel flow is __________ that for counter flow.
Options- A. equal to
- B. less than
- C. greater than Discuss
- 4. An atom bomb utilises uncontrolled nuclear fission.
Options- A. True
- B. False Discuss
- 5. The maximum flame temperature occurs
Options- A. at the outer cone
- B. at the inner cone
- C. between the outer and inner cone
- D. at the torch tip Discuss
- 6. The forces, whose lines of action are parallel to each other and act in the same directions, are known as
Options- A. coplaner concurrent forces
- B. coplaner non-concurrent forces
- C. like parallel forces
- D. unlike parallel forces Discuss
- 7. The efficiency of reaction turbine is maximum when (where ? = Angle made by the absolute velocity (V) at inlet)
Options- A. Vb = 0.5 V cos ?
- B. Vb = V cos ?
- C. Vb = 0.5 V2 cos ?
- D. Vb = V2 cos ? Discuss
- 8. The sequence order of events in a four-stroke engine is
Options- A. suction - exhaust - power - compression
- B. suction - power - compression - exhaust
- C. suction - compression - power - exhaust
- D. exhaust - compression - power - suction Discuss
- 9. Shift is a casting defect which
Options- A. results in a mismatching of the top and bottom parts of a casting
- B. results in general enlargement of a casting
- C. occurs near the ingates as rough lumps on the surface of a casting
- D. occurs as sand patches on the upper surface of a casting Discuss
- 10. Linde welding uses
Options- A. neutral flame and right-ward technique
- B. oxidising flame and left-ward technique
- C. neutral flame and left-ward technique
- D. carburising flame and right-ward technique Discuss
More questions
Correct Answer: lies below
Correct Answer: maintains directional control during braking by preventing the wheels from locking
Correct Answer: equal to
Correct Answer: True
Correct Answer: at the inner cone
Correct Answer: like parallel forces
Correct Answer: Vb = V cos ?
Correct Answer: suction - compression - power - exhaust
Correct Answer: results in a mismatching of the top and bottom parts of a casting
Correct Answer: carburising flame and right-ward technique
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.