Discussion
Home ‣ Mechanical Engineering ‣ Hydraulics and Fluid Mechanics Comments
- Question
In two dimensional flow, the flow does not take place in a curve.
Options- A. True
- B. False
- Correct Answer
- False
- 1. The purpose of a surge tank is
Options- A. to control the pressure variations due to rapid changes in the pipe line flow
- B. to eliminate water hammer possibilities
- C. to regulate flow of water to turbines by providing necessary retarding head of water
- D. all of the above Discuss
- 2. A channel is said to be of most economical cross-section, if
Options- A. it gives maximum discharge for a given cross-sectional area and bed slope
- B. it has minimum wetted perimeter
- C. it involves lesser excavation for the designed amount of discharge
- D. all of the above Discuss
- 3. The ratio of specific weight of a liquid to the specific weight of pure water at a standard temperature is called
Options- A. density of liquid
- B. specific gravity of liquid
- C. compressibility of liquid
- D. surface tension of liquid Discuss
- 4. A thick liquid like a syrup has a __________ viscosity than a light liquid like water.
Options- A. lesser
- B. greater Discuss
- 5. The pressure of liquid at throat in a venturimeter is __________ than that at inlet.
Options- A. higher
- B. lower Discuss
- 6. The discharge through a channel of circular section will be maximum when the depth of water is __________ the diameter of the circular channel.
Options- A. 0.34 times
- B. 0.67 times
- C. 0.81 times
- D. 0.95 times Discuss
- 7. The error in discharge (dQ/Q) to the error in measurement of head (dH/H) over a triangular notch is given by
Options- A.
- B.
- C.
- D.
Discuss
- 8. In an internal mouthpiece, if the jet after contraction expands and fills up the whole mouthpiece, then the mouthpiece is said to be running free.
Options- A. True
- B. False Discuss
- 9. The specific gravity of an oil whose specific weight is 7.85 kN/m3, is
Options- A. 0.8
- B. 1
- C. 1.2
- D. 1.6 Discuss
- 10. The coefficient of discharge is the ratio of dieoretical discharge to the actual discharge through an orifice.
Options- A. True
- B. False Discuss
Hydraulics and Fluid Mechanics problems
Search Results
Correct Answer: all of the above
Correct Answer: all of the above
Correct Answer: specific gravity of liquid
Correct Answer: greater
Correct Answer: lower
Correct Answer: 0.95 times
Correct Answer:
Correct Answer: False
Correct Answer: 0.8
Correct Answer: False
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.