logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Hydraulics and Fluid Mechanics Comments

  • Question
  • The celerity (velocity) of a pressure wave in a fluid is given by (where K = Bulk modulus, and ? = Density of the fluid)


  • Options
  • A. K.?
  • B. K/?
  • C. ?/K
  • D. K.?

  • Correct Answer
  • K/? 


  • Hydraulics and Fluid Mechanics problems


    Search Results


    • 1. The total energy of a liquid particle in motion is equal to

    • Options
    • A. pressure energy + kinetic energy + potential energy
    • B. pressure energy - (kinetic energy + potential energy)
    • C. potential energy - (pressure energy + kinetic energy
    • D. kinetic energy - (pressure energy + potential energy)
    • Discuss
    • 2. A flow through a long pipe at decreasing rate is called __________ uniform flow.

    • Options
    • A. steady
    • B. unsteady
    • Discuss
    • 3. The factional resistance of a pipe varies approximately with __________ of the liquid.

    • Options
    • A. pressure
    • B. velocity
    • C. square of velocity
    • D. cube of velocity
    • Discuss
    • 4. The point at which the resultant pressure on an immersed surface acts, is known as

    • Options
    • A. centre of gravity
    • B. centre of depth
    • C. centre of pressure
    • D. centre of immersed surface
    • Discuss
    • 5. If the coefficient of discharge is 0.6, then the discharge over a right angled notch is

    • Options
    • A. 0.417 H5/2
    • B. 1.417 H5/2
    • C. 4.171 H5/2
    • D. 7.141 H5/2
    • Discuss
    • 6. The hydraulic gradient line is always parallel to the centre line of the pipe.

    • Options
    • A. Correct
    • B. Incorrect
    • Discuss
    • 7. The volume of a fluid __________ as the pressure increases.

    • Options
    • A. remains same
    • B. decreases
    • C. increases
    • Discuss
    • 8. A differential manometer is used to measure

    • Options
    • A. atmospheric pressure
    • B. pressure in pipes and channels
    • C. pressure in venturimeter
    • D. difference of pressures between two points in a pipe
    • Discuss
    • 9. The surface tension of mercury at normal temperature is __________ that of water.

    • Options
    • A. same as
    • B. lower than
    • C. higher than
    • Discuss
    • 10. The D-Alembert's principle is used for changing the dynamic equilibrium of a fluid mass, into a static equilibrium.

    • Options
    • A. Agree
    • B. Disagree
    • Discuss


    Comments

    There are no comments.

Enter a new Comment