logo

CuriousTab

CuriousTab

Discussion

Home ‣ Mechanical Engineering ‣ Hydraulics and Fluid Mechanics See What Others Are Saying!
  • Question

  • The torque required to overcome viscous resistance of a footstep bearing is (where ? = Viscosity of the oil, N = Speed of the shaft, R = Radius of the shaft, and t = Thickness of the oil film)


  • Options
  • A. The torque required to overcome viscous resistance of a footstep bearing is (where ? = Viscosity of
  • B. The torque required to overcome viscous resistance of a footstep bearing is (where ? = Viscosity of
  • C. The torque required to overcome viscous resistance of a footstep bearing is (where ? = Viscosity of
  • D. The torque required to overcome viscous resistance of a footstep bearing is (where ? = Viscosity of

  • Correct Answer
  •  

    • More questions

    • 1. In spot welding, the spacing between two spot weld should not be less than

    • Options
    • A. d
    • B. 1.5 d
    • C. 3 d
    • D. 6 d
      • Discuss
    • 2. The total energy line lies over the centre line of the pipe by an amount equal to

    • Options
    • A. pressure head
    • B. velocity head
    • C. pressure head + velocity head
    • D. pressure head - velocity head
      • Discuss
    • 3. The efficiency of Diesel cycle increases with

    • Options
    • A. decrease in cut-off
    • B. increase in cut-off
    • C. constant cut-off
    • D. none of these
      • Discuss
    • 4. The value of 1 mm of Hg is equal to

    • Options
    • A. 1.333 N/m2
    • B. 13.33 N/m2
    • C. 133.3 N/m2
    • D. 1333 N/m2
      • Discuss
    • 5. According to principle of conservation of energy, the total momentum of a system of masses in any direction remains constant unless acted upon by an external force in that direction.

    • Options
    • A. True
    • B. False
      • Discuss
    • 6. The lip angle of a single point tool is usually

    • Options
    • A. 20° to 40°
    • B. 40° to 60°
    • C. 60° to 80°
    • D. none of these
      • Discuss
    • 7. The maximum internal diameter of a blast furnace is about

    • Options
    • A. 3 m
    • B. 6 m
    • C. 9 m
    • D. 12 m
      • Discuss
    • 8. A mortise gauge is a

    • Options
    • A. striking tool
    • B. planing tool
    • C. boring tool
    • D. marking tool
      • Discuss
    • 9. Incoloy, Hastelloy and Vitallium are __________ temperature alloys.

    • Options
    • A. high
    • B. low
      • Discuss
    • 10. The torque available at the contact between driving wheels and road is known as

    • Options
    • A. brake effort
    • B. tractive effort
    • C. clutch effort
    • D. none of these
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.