Discussion
Home ‣ Mechanical Engineering ‣ Hydraulics and Fluid Mechanics See What Others Are Saying!
- Question
The force exerted by a moving fluid on an immersed body is directly proportional to the rate of change of momentum due to the presence of the body. This statement is called
Options- A. Newton's law of motion
- B. Newton's law of cooling
- C. Newton's law of viscosity
- D. Newton's law of resistance
- Correct Answer
- Newton's law of resistance
- 1. In spot welding, the spacing between two spot weld should not be less than
Options- A. d
- B. 1.5 d
- C. 3 d
- D. 6 d Discuss
- 2. The total energy line lies over the centre line of the pipe by an amount equal to
Options- A. pressure head
- B. velocity head
- C. pressure head + velocity head
- D. pressure head - velocity head Discuss
- 3. The efficiency of Diesel cycle increases with
Options- A. decrease in cut-off
- B. increase in cut-off
- C. constant cut-off
- D. none of these Discuss
- 4. The value of 1 mm of Hg is equal to
Options- A. 1.333 N/m2
- B. 13.33 N/m2
- C. 133.3 N/m2
- D. 1333 N/m2 Discuss
- 5. According to principle of conservation of energy, the total momentum of a system of masses in any direction remains constant unless acted upon by an external force in that direction.
Options- A. True
- B. False Discuss
- 6. The lip angle of a single point tool is usually
Options- A. 20° to 40°
- B. 40° to 60°
- C. 60° to 80°
- D. none of these Discuss
- 7. The maximum internal diameter of a blast furnace is about
Options- A. 3 m
- B. 6 m
- C. 9 m
- D. 12 m Discuss
- 8. A mortise gauge is a
Options- A. striking tool
- B. planing tool
- C. boring tool
- D. marking tool Discuss
- 9. Incoloy, Hastelloy and Vitallium are __________ temperature alloys.
Options- A. high
- B. low Discuss
- 10. The torque available at the contact between driving wheels and road is known as
Options- A. brake effort
- B. tractive effort
- C. clutch effort
- D. none of these Discuss
More questions
Correct Answer: 3 d
Correct Answer: pressure head + velocity head
Correct Answer: decrease in cut-off
Correct Answer: 133.3 N/m2
Correct Answer: False
Correct Answer: 60° to 80°
Correct Answer: 9 m
Correct Answer: marking tool
Correct Answer: high
Correct Answer: tractive effort
Comments
There are no comments.More in Mechanical Engineering:
Automobile EngineeringCompressors, Gas Dynamics and Gas TurbinesEngineering MaterialsEngineering MechanicsHeat Transfer, Refrigeration and Air ConditioningHydraulic MachinesHydraulics and Fluid MechanicsIC Engines and Nuclear Power PlantsIndustrial Engineering and Production ManagementMachine DesignProduction EngineeringSteam Boilers and EnginesSteam Nozzles and TurbinesStrength of MaterialsTheory of machinesThermodynamicsWorkshop TechnologyProgramming
Copyright ©CuriousTab. All rights reserved.