logo

CuriousTab

CuriousTab

Discussion

Home ‣ Mechanical Engineering ‣ Hydraulics and Fluid Mechanics Comments
  • Question

  • The efficiency of power transmission through pipe is (where H = Total supply head, and hf = Head lost due to friction in the pipe)


  • Options
  • A. The efficiency of power transmission through pipe is (where H = Total supply head, and hf = Head los
  • B. The efficiency of power transmission through pipe is (where H = Total supply head, and hf = Head los
  • C. The efficiency of power transmission through pipe is (where H = Total supply head, and hf = Head los
  • D. The efficiency of power transmission through pipe is (where H = Total supply head, and hf = Head los

  • Correct Answer
  •  

    • Hydraulics and Fluid Mechanics problems

    Search Results

    • 1. A vertically immersed surface is shown in the below figure. The distance of its centre of pressure from the water surface is

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 2. The ratio of the inertia force to the gravity force is called Froude number.

    • Options
    • A. Agree
    • B. Disagree
      • Discuss
    • 3. The velocity at which the laminar flow stops, is known as

    • Options
    • A. velocity of approach
    • B. lower critical velocity
    • C. higher critical velocity
    • D. none of these
      • Discuss
    • 4. The flow of water through the hole in the bottom of a wash basin is an example of

    • Options
    • A. steady flow
    • B. uniform flow
    • C. free vortex
    • D. forced vortex
      • Discuss
    • 5. The tendency of a liquid to uplift a submerged body, because of the upward thrust of the liquid, is known as buoyancy.

    • Options
    • A. Agree
    • B. Disagree
      • Discuss
    • 6. A water tank contains 1.3 m deep water. The pressure exerted by the water per metre length of the tank is

    • Options
    • A. 2.89 kN
    • B. 8.29 kN
    • C. 9.28 kN
    • D. 28.9 kN
      • Discuss
    • 7. A glass tube of smaller diameter is used while performing an experiment for the capillary rise of water because

    • Options
    • A. it is easier to see through the glass tube
    • B. glass tube is cheaper than a metallic tube
    • C. it is not possible to conduct this experiment with any other tube
    • D. all of the above
      • Discuss
    • 8. A manometer can be used to measure vacuum pressures.

    • Options
    • A. Agree
    • B. disagree
      • Discuss
    • 9. The error in discharge (dQ/Q) to the error in measurement of head (dH/H) over a rectangular notch is given by

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 10. A flow in which __________ force is dominating over the viscosity is called turbulent flow.

    • Options
    • A. elastic
    • B. surface tension
    • C. viscous
    • D. inertia
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.