Discussion
Home ‣ Mechanical Engineering ‣ Hydraulics and Fluid Mechanics See What Others Are Saying!
- Question
A compound pipe of diameter d1, d2 and d3 having lengths l1, l2 and l3 is to be replaced by an equivalent pipe of uniform diameter d and of the same length (l) as that of the compound pipe. The size of the equivalent pipe is given by
Options- A.
- B.
- C.
- D.
- Correct Answer
-
- 1. The conditioned air supplied to the room must have the capacity to take up
Options- A. room sensible heat load only
- B. room latent heat load only
- C. both room sensible heat and latent heat loads
- D. none of the above Discuss
- 2. The alignment circle is marked on the psychrometric chart at
Options- A. 20°C DBT and 50% RH
- B. 26°C DBT and 50% RH
- C. 20°C DBT and 60% RH
- D. 26°C DBT and 60% RH Discuss
- 3. The thermal diffusivity for gases is generally __________ those for liquids.
Options- A. equal to
- B. less than
- C. greater than Discuss
- 4. A stripper-plate machine is used to draw the pattern from the mould.
Options- A. Yes
- B. No Discuss
- 5. Steam turbines are used for
Options- A. large marine propulsion
- B. electric power generation
- C. direct drive of fans, compressors, pumps
- D. all of these Discuss
- 6. Two shafts 'A' and 'B' are made of same material. The shaft 'A' is of diameter D and shaft 'B' is of diameter D/2. The strength of shaft 'B' is __________ as that of shaft 'A'
Options- A. one-eighth
- B. one-fourth
- C. one-half
- D. four times Discuss
- 7. The shear force at apoint on a beam is the algebraic __________ of all the forces on either side of the point.
Options- A. sum
- B. difference Discuss
- 8. Shear modulus is the ratio of
Options- A. linear stress to linear strain
- B. linear stress to lateral strain
- C. volumetric strain to linear strain
- D. shear stress to shear strain Discuss
- 9. The presence of hydrogen in steel causes
Options- A. reduced neutron absorption cross-section
- B. improved weldability
- C. embrittlement
- D. corrosion resistance Discuss
- 10. The brake pedal during ABS operation
Options- A. is pushed upward forcefully
- B. pedal stroke becomes longer
- C. transmits slight kickback to the driver's foot
- D. all of the above Discuss
More questions
Correct Answer: both room sensible heat and latent heat loads
Correct Answer: 26°C DBT and 50% RH
Correct Answer: greater than
Correct Answer: Yes
Correct Answer: all of these
Correct Answer: one-eighth
Correct Answer: sum
Correct Answer: shear stress to shear strain
Correct Answer: embrittlement
Correct Answer: transmits slight kickback to the driver's foot
Comments
There are no comments.More in Mechanical Engineering:
Automobile EngineeringCompressors, Gas Dynamics and Gas TurbinesEngineering MaterialsEngineering MechanicsHeat Transfer, Refrigeration and Air ConditioningHydraulic MachinesHydraulics and Fluid MechanicsIC Engines and Nuclear Power PlantsIndustrial Engineering and Production ManagementMachine DesignProduction EngineeringSteam Boilers and EnginesSteam Nozzles and TurbinesStrength of MaterialsTheory of machinesThermodynamicsWorkshop TechnologyProgramming
Copyright ©CuriousTab. All rights reserved.