logo

CuriousTab

CuriousTab

Discussion

Home ‣ Mechanical Engineering ‣ Engineering Mechanics Comments
  • Question

  • Moment of inertia of a hollow rectangular section as shown in the below figure about X-X axis, is
    Moment of inertia of a hollow rectangular section as shown in the below figure about X-X axis, is


  • Options
  • A. Moment of inertia of a hollow rectangular section as shown in the below figure about X-X axis, is
  • B. Moment of inertia of a hollow rectangular section as shown in the below figure about X-X axis, is
  • C. Moment of inertia of a hollow rectangular section as shown in the below figure about X-X axis, is
  • D. Moment of inertia of a hollow rectangular section as shown in the below figure about X-X axis, is

  • Correct Answer
  •  

    • Engineering Mechanics problems

    Search Results

    • 1. The motion of the body from one extremity to the other is known as a beat.

    • Options
    • A. Agree
    • B. Disagree
      • Discuss
    • 2. The time of flight of a projectile on downward inclined plane depends upon

    • Options
    • A. angle of projection
    • B. angle of inclination of the plane
    • C. both (a) and (b)
    • D. none of these
      • Discuss
    • 3. The centre of gravity of a rectangle lies at a point where its two diagonals meet each other.

    • Options
    • A. Agree
    • B. Disagree
      • Discuss
    • 4. Two equal and opposite parallel forces whose lines of action are different, can be replaced by a single force parallel to the given forces.

    • Options
    • A. Correct
    • B. Incorrect
      • Discuss
    • 5. The force applied on a body of mass 100 kg to produce an acceleration of 5 m/s2, is

    • Options
    • A. 20N
    • B. 100N
    • C. 500N
    • D. none of these
      • Discuss
    • 6. The force induced in the string BC due to the load W as shown in the below figure is

    • Options
    • A. W sin ?
    • B. W cos ?
    • C. W tan ?
    • D. W cot ?
      • Discuss
    • 7. The velocity ratio of a differential wheel and axle with D as the diameter of effort wheel and d1,and d2 as the diameters of larger and smaller axles respectively, is

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 8. A framed structure is perfect, if the number of members are __________ (2j - 3), where j is the number of joints.

    • Options
    • A. equal to
    • B. less than
    • C. greater than
    • D. either (b) or (c)
      • Discuss
    • 9. Which of the following statement is correct?

    • Options
    • A. The algebraic sum of the forces, constituting the couple is zero.
    • B. The algebraic sum of the forces, constituting the couple, about any point is the same.
    • C. A couple cannot be balanced by a single force but can be balanced only by a couple of opposite sense.
    • D. all of the above
      • Discuss
    • 10. The hydraulic gradient line may be above or below the centre line of the pipe.

    • Options
    • A. True
    • B. False
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.