Discussion
Home ‣ Chemical Engineering ‣ Furnace Technology Comments
- Question
Cement Kiln is a
Options- A. rotary Kiln
- B. tunnel Kiln
- C. natural draft furnace
- D. batch furnace
- Correct Answer
- rotary Kiln
- 1. The amount of combustible escaping uncon-sumed from the furnace, depends upon the
Options- A. air supplied and furnace temperature.
- B. burner design (thoroughness of mixing versus stratification).
- C. air preheat and the flow of gases in the furnace (mixing by induction, by acceleration or by change of direction).
- D. all (a), (b) and (c). Discuss
- 2. Regenerators are installed in
Options- A. coke ovens
- B. open hearth furnace
- C. both (a) & (b)
- D. neither (a) nor (b) Discuss
- 3. Ceramic recuperators compared to metallic recuperators for the same duty
Options- A. are lighter.
- B. occupy more space.
- C. are less costly.
- D. have higher pressure differential between flue gas & air side. Discuss
- 4. Pulverised fuel fired furnaces employ __________ fuel firing.
Options- A. horizontal
- B. vertical
- C. tangential
- D. all (a), (b) and (c) Discuss
- 5. Example of an indirectly heated furnace is
Options- A. hood annealing furnace
- B. muffle furnace
- C. both (a) and (b)
- D. neither (a) nor (b) Discuss
- 6. Temperature of a furnace fired with low calorific value fuel gas (i.e. lean gas) can be increased by
Options- A. preheating the combustion air.
- B. oxygen enrichment of combustion air.
- C. preheating the fuel gas.
- D. all (a), (b) & (c). Discuss
- 7. Ceramic coating material for furnace refractory, which increases its emissivity and thus the radiation heat transfer rate in the furnace, comprises of
Options- A. graphite powder
- B. thoria
- C. zircon powder
- D. beryllium Discuss
- 8. Thermal efficiency of blast furnace stoves used for heating blast (air) may be about __________ percent.
Options- A. 20
- B. 40
- C. 60
- D. 80 Discuss
- 9. Power required in case of forced draught as compared to induced draught (for the same draught produced) is
Options- A. same
- B. less
- C. more
- D. either more or less; depends on the flue gas density Discuss
- 10. Which of the following is not a directly fired furnace?
Options- A. By-product coke oven
- B. Calcination kiln
- C. Sintering furnace
- D. Open hearth furnace Discuss
Furnace Technology problems
Search Results
Correct Answer: all (a), (b) and (c).
Correct Answer: both (a) & (b)
Correct Answer: occupy more space.
Correct Answer: all (a), (b) and (c)
Correct Answer: both (a) and (b)
Correct Answer: all (a), (b) & (c).
Correct Answer: zircon powder
Correct Answer: 80
Correct Answer: less
Correct Answer: By-product coke oven
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.