Discussion
Home ‣ Chemical Engineering ‣ Furnace Technology Comments
- Question
The reason for excessive clinker formation in gas producers is the
Options- A. use of coal/coke containing a high % of fines and ash.
- B. use of fuel having too low an ash fusion temperature.
- C. development of hot spots in the fuel bed and an abnormally high rate of gasification.
- D. all (a), (b) and (c).
- Correct Answer
- all (a), (b) and (c).
- 1. Which of the following is a component of working capital investment?
Options- A. Utilities plants.
- B. Maintenance and repair inventory.
- C. Process equipments.
- D. Depreciation. Discuss
- 2. __________ of depreciation calculation accounts for the interest on investement.
Options- A. Straight line method
- B. Declining balance
- C. both (a) and (b)
- D. neither (a) nor (b). Discuss
- 3. The economic life of a large chemical process plant as compared to a small chemical plant is
Options- A. only slightly more
- B. much more
- C. slightly less
- D. almost equal Discuss
- 4. Annual depreciation cost are not constant when, the __________ method of depreciation calculation is used.
Options- A. straight line
- B. sinking fund
- C. present worth
- D. declining balance. Discuss
- 5. Pick out the wrong statement.
Options- A. The annual depreciation rate for machinery and equipments in a chemical process plant is about 10% of the fixed capital investment.
- B. Annual depreciation rate of buildings in a chemical plant is about 3% of its initial cost.
- C. Insurance rates on annual basis in a chemical plant may be about 1% of the fixed capital investment.
- D. In a chemical industry, research and development cost amounts to about 15% of net sales realisation (NSR). Discuss
- 6. Heat transfer rate to the stock/charge in the furnace does not depend upon the
Options- A. emissivity of the refactory walls.
- B. size of the furance.
- C. use of waste heat recovery equipments.
- D. thickness of the stock. Discuss
- 7. Thermal efficiency of a limestone calcination rotary kiln may be around __________ percent.
Options- A. 20
- B. 40
- C. 65
- D. 80 Discuss
- 8. Which of the following is a natural draft furnace?
Options- A. Blast furnace stoves
- B. Power plant boilers
- C. Sintering furnace
- D. None of these Discuss
- 9. Soaking pits are meant for heating steel
Options- A. ingots
- B. coils
- C. sheets
- D. slabs Discuss
- 10. Which is the most thermally efficient furnace?
Options- A. Reheating furnace
- B. Reverberatory furnace
- C. Rotary kilns
- D. Boiler furnace Discuss
Furnace Technology problems
Search Results
Correct Answer: Maintenance and repair inventory.
Correct Answer: neither (a) nor (b).
Correct Answer: much more
Correct Answer: declining balance.
Correct Answer: In a chemical industry, research and development cost amounts to about 15% of net sales realisation (NSR).
Correct Answer: use of waste heat recovery equipments.
Correct Answer: 40
Correct Answer: Blast furnace stoves
Correct Answer: ingots
Correct Answer: Boiler furnace
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.