logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Chemical Process Comments

  • Question
  • Concentration of NaOH solution produced by mercury electrolytic cell is about __________ percent.


  • Options
  • A. 10
  • B. 25
  • C. 50
  • D. 98

  • Correct Answer
  • 50 


  • Chemical Process problems


    Search Results


    • 1. Sulphur addition in soap is done to

    • Options
    • A. improve the soap texture.
    • B. cure pimples & dandruff.
    • C. fasten lather formation.
    • D. increase its cleansing action.
    • Discuss
    • 2. In sulphate pulp manufacture, the pressure and temperature in the digestor is

    • Options
    • A. 10 atm., 800 °C
    • B. 10 atm., 170-180°C
    • C. 1 atm., 170 - 180°C
    • D. l atm., 800°C
    • Discuss
    • 3. Producer gas consists mainly of

    • Options
    • A. CO, CO2 N2, H2
    • B. CO, H2
    • C. H2, CH4
    • D. C2H2, CO2, H2
    • Discuss
    • 4. All enzymes are made of

    • Options
    • A. fats
    • B. carbohydrates
    • C. proteins
    • D. amino acids
    • Discuss
    • 5. In the Lurgi coal gasifier

    • Options
    • A. coking coals cannot be used.
    • B. low carbon conversion efficiency is achieved.
    • C. entrainment of solids is higher.
    • D. large quantity of coal can be processed.
    • Discuss
    • 6. Hard water

    • Options
    • A. does not affect the lather formation by soap.
    • B. is not unfit for drinking purpose.
    • C. pollutes the water stream.
    • D. all (a), (b) and (c).
    • Discuss
    • 7. The chamber process is

    • Options
    • A. preferred over contact process for producing 98 to 100% H2SO4 and various oleums.
    • B. non-catalytic and operates only on pyrites.
    • C. a batch process for directly producing high strength (98 to 100%) H2SO4.
    • D. none of these.
    • Discuss
    • 8. Neoprene is the trade name of

    • Options
    • A. polyurathane
    • B. phenol formaldehyde
    • C. polychloroprene
    • D. styrene-butadiene rubber
    • Discuss
    • 9. Epoxy resin

    • Options
    • A. is a good adhesive.
    • B. is an elastomer.
    • C. cannot be used for surface coatings.
    • D. is a polyester.
    • Discuss
    • 10. The main use of HCl is in the

    • Options
    • A. drilling of petroleum wells and pickling of steel sheets.
    • B. manufacture of cationic detergent.
    • C. treatment of spent fuel of nuclear reactor.
    • D. none of these.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment