Discussion
Home ‣ Chemical Engineering ‣ Mechanical Operations Comments
- Question
__________ is the most commonly used 'filter aid'.
Options- A. Diatomaceous earth
- B. Fuller's earth
- C. Vermiculite
- D. Semi-plastic clay
- Correct Answer
- Diatomaceous earth
- 1. Sulphuric acid mist is arrested by using a __________ scrubber.
Options- A. packed wet
- B. hollow wet
- C. venturi
- D. co-current Discuss
- 2. Crushing of mineral particles is accomplished in a 'cage mill', when one or more alloy steel bars are revolved in opposite directions. It is a type of __________ mill.
Options- A. impact
- B. roll
- C. vibratory
- D. none of these Discuss
- 3. Range of compressibility co-efficient of the commercial compressible cake obtained in filtration operation is
Options- A. 0.01 to 0.1
- B. 0.1 to 0.3
- C. 0.2 to 0.8
- D. 0.2 to 0.4 Discuss
- 4. The capacity of a belt conveyor depends upon two factors. If one is the cross-section of the load, the other is the __________ of the belt.
Options- A. speed
- B. thickness
- C. length
- D. none of these Discuss
- 5. Solid particles separation based on the difference in their flow velocities through fluids is termed as the
Options- A. clarification
- B. classification
- C. elutriation
- D. sedimentation Discuss
- 6. Which of the following is not a part of the Blake jaw crusher?
Options- A. Hanger
- B. Check plates
- C. Toggles
- D. Pitman Discuss
- 7. Size reduction of the __________ can be suitably done by ball mills, crushing rolls and rod mills.
Options- A. metalliferrous ores
- B. non-metallic ores
- C. basic slags
- D. asbestos & mica Discuss
- 8. Which of the following is the most suitable for cleaning of fine coal dust (<0.5 mm)?
Options- A. Trough washer
- B. Baum jig washer
- C. Spiral separator
- D. Froth floatation Discuss
- 9. Gravity settling process is not involved in the working of a
Options- A. hydrocyclone
- B. classifier
- C. dorr-thickener
- D. sedimentation tank Discuss
- 10. Number of particles in a crushed solid sample is given by (where, m = mass of particles in a sample, Vp = volume of one particle, ?= density of particles)
Options- A. m/? . Vp
- B. m . ?/Vp
- C. m . Vp/?
- D. Vp/m . ? Discuss
Mechanical Operations problems
Search Results
Correct Answer: venturi
Correct Answer: impact
Correct Answer: 0.2 to 0.8
Correct Answer: speed
Correct Answer: classification
Correct Answer: Hanger
Correct Answer: metalliferrous ores
Correct Answer: Froth floatation
Correct Answer: hydrocyclone
Correct Answer: m/? . Vp
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.