Discussion
Home ‣ Chemical Engineering ‣ Mechanical Operations Comments
- Question
For sizing of fine materials, the most suitable equipment is a
Options- A. trommel
- B. grizzly
- C. shaking screen
- D. vibrating screen
- Correct Answer
- vibrating screen
- 1. The value of 'angle of nip' is generally about
Options- A. 16°
- B. 32°
- C. 52°
- D. 64° Discuss
- 2. Pick out the wrong statement pertaining to the roll crushers.
Options- A. Maximum feed size determines the required roll diameter.
- B. For hard material's crushing, the reduction ratio should not exceed 4.
- C. Both the rolls run necessarily at the same speed.
- D. Reduction ratio and differential roll speed affect production rate & energy consumed per unit of surface produced. Discuss
- 3. In case of a hammer crusher,
Options- A. crushing takes place by impact breaking.
- B. maximum acceptable feed size is 30 cms.
- C. reduction ratio can be varied by adjusting the distance from cage to hammers.
- D. all (a), (b) and (c). Discuss
- 4. In washing type plate and frame filter press, the ratio of washing rate to the final filtrate rate is
Options- A. 4
- B. 1/4
- C. 1
- D. 1/2 Discuss
- 5. Which of the following is not categorised as a "mechanical operation"?
Options- A. Agitation
- B. Filtration
- C. Size enlargement
- D. Humidification Discuss
- 6. If a force greater than that of gravity is used to separate solids & fluids of different densities, the process is termed as the
Options- A. sedimentation
- B. flocculation
- C. dispersion
- D. centrifugation Discuss
- 7. Pick out the wrong statement.
Options- A. Recycled coarse material to the grinder by a classifier is termed as circulating load.
- B. Wear and tear in wet crushing is more than that in dry crushing of materials.
- C. Size enlargement (opposite of size reduction) is not a mechanical operation.
- D. A 'dust catcher' is simply an enlargement in a pipeline which permits the solids to settle down due to reduction in velocity of the dust laden gas. Discuss
- 8. Solid particles separation based on the difference in their flow velocities through fluids is termed as the
Options- A. clarification
- B. classification
- C. elutriation
- D. sedimentation Discuss
- 9. The capacity of a belt conveyor depends upon two factors. If one is the cross-section of the load, the other is the __________ of the belt.
Options- A. speed
- B. thickness
- C. length
- D. none of these Discuss
- 10. Range of compressibility co-efficient of the commercial compressible cake obtained in filtration operation is
Options- A. 0.01 to 0.1
- B. 0.1 to 0.3
- C. 0.2 to 0.8
- D. 0.2 to 0.4 Discuss
Mechanical Operations problems
Search Results
Correct Answer: 32°
Correct Answer: Both the rolls run necessarily at the same speed.
Correct Answer: all (a), (b) and (c).
Correct Answer: 1/4
Correct Answer: Humidification
Correct Answer: centrifugation
Correct Answer: Size enlargement (opposite of size reduction) is not a mechanical operation.
Correct Answer: classification
Correct Answer: speed
Correct Answer: 0.2 to 0.8
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.