Discussion
Home ‣ Chemical Engineering ‣ Mechanical Operations Comments
- Question
In washing type plate and frame filter press, the ratio of washing rate to the final filtrate rate is
Options- A. 4
- B. 1/4
- C. 1
- D. 1/2
- Correct Answer
- 1/4
- 1. Which of the following is not categorised as a "mechanical operation"?
Options- A. Agitation
- B. Filtration
- C. Size enlargement
- D. Humidification Discuss
- 2. Balls for ball mills are never made of
Options- A. forged/cast steel
- B. lead
- C. cast iron
- D. alloy steel Discuss
- 3. Froth floatation is the most suitable for treating
Options- A. iron ores
- B. sulphide ores
- C. quartzite
- D. none of these Discuss
- 4. Pick out the correct statement:
Options- A. Removal of iron from ceramic material is necessitated (by magnetic separation method) so as to avoid discolouration of ceramic products.
- B. The operating cost of shaking screen is more than that of a vibrating screen.
- C. Screen capacity does not depend upon the specific gravity of the minerals.
- D. Asphalt is best crushed using toothed roll crusher. Discuss
- 5. In continuous filtration (at a constant pressure drop), filtrate flow rate varies inversely as the
Options- A. square root of the velocity.
- B. square of the viscosity.
- C. filtration time only.
- D. washing time only. Discuss
- 6. In case of a hammer crusher,
Options- A. crushing takes place by impact breaking.
- B. maximum acceptable feed size is 30 cms.
- C. reduction ratio can be varied by adjusting the distance from cage to hammers.
- D. all (a), (b) and (c). Discuss
- 7. Pick out the wrong statement pertaining to the roll crushers.
Options- A. Maximum feed size determines the required roll diameter.
- B. For hard material's crushing, the reduction ratio should not exceed 4.
- C. Both the rolls run necessarily at the same speed.
- D. Reduction ratio and differential roll speed affect production rate & energy consumed per unit of surface produced. Discuss
- 8. The value of 'angle of nip' is generally about
Options- A. 16°
- B. 32°
- C. 52°
- D. 64° Discuss
- 9. For sizing of fine materials, the most suitable equipment is a
Options- A. trommel
- B. grizzly
- C. shaking screen
- D. vibrating screen Discuss
- 10. If a force greater than that of gravity is used to separate solids & fluids of different densities, the process is termed as the
Options- A. sedimentation
- B. flocculation
- C. dispersion
- D. centrifugation Discuss
Mechanical Operations problems
Search Results
Correct Answer: Humidification
Correct Answer: lead
Correct Answer: sulphide ores
Correct Answer: Removal of iron from ceramic material is necessitated (by magnetic separation method) so as to avoid discolouration of ceramic products.
Correct Answer: square root of the velocity.
Correct Answer: all (a), (b) and (c).
Correct Answer: Both the rolls run necessarily at the same speed.
Correct Answer: 32°
Correct Answer: vibrating screen
Correct Answer: centrifugation
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.