Discussion
Home ‣ Chemical Engineering ‣ Refractory Technology Comments
- Question
With increase in the porosity, thermal spalling resistance of fireclay brick
Options- A. increases
- B. decreases
- C. remains same
- D. may increase or decrease
- Correct Answer
- increases
- 1. Beryllia (which is used in making crucibles for melting uranium & thorium) is superior to alumina in all respects for high temperature (> 1900°C ) use, except
Options- A. cost
- B. electrical conductivity
- C. thermal conductivity
- D. fusion point Discuss
- 2. Resistance to slag attack of a refractory
Options- A. depends on the nature of slag & refractory.
- B. decreases at higher temperature.
- C. decreases, if defective joints & cracks exist in the refractory.
- D. all (a), (b) and (c). Discuss
- 3. Which is not a basic refractory?
Options- A. Chrome magnesite
- B. Magnesite
- C. Dolomite
- D. Silicon carbide Discuss
- 4. Which property of refractories is the most important for top section of the blast furnace?
Options- A. Resistance to abrasion.
- B. Resistance to slag peneration.
- C. Stability of volume at high temperature.
- D. Resistance to corrosion by slag. Discuss
- 5. Which of these statement is correct?
Options- A. Conversion of quartz to tridymite is associated with 16% volume increase.
- B. Conversion of tridymite to crystoballite involves very large expansion in volume.
- C. both (a) and (b).
- D. neither (a) nor (b). Discuss
- 6. Magnesite bricks are used in those parts of furnaces, which are
Options- A. subjected to temperature fluctuation.
- B. required to resist corrosive basic slag.
- C. subjected to high load.
- D. none of these. Discuss
- 7. Spray test determines the __________ of refractories.
Options- A. resistance to slag penetration
- B. resistance to CO attack
- C. RUL
- D. permanent linear change Discuss
- 8. Natural rubber is obtained from latex, which is a colloidal dispersion of rubber in water. Which of the following is used as a coagulant in latex?
Options- A. Ammonium alum
- B. Potassium alum
- C. both a & b
- D. neither a nor b Discuss
- 9. Transistor parts and refrigerator components are normally made of
Options- A. polystyrene
- B. polyester
- C. high density polythene
- D. polyurathane Discuss
- 10. 90% of the caprolactum is converted to nylon-6 on its condensation polymerisation in the reactor maintained at a temperature of __________ °C.
Options- A. -5
- B. 10-30
- C. 250-280
- D. 500-600 Discuss
Refractory Technology problems
Search Results
Correct Answer: cost
Correct Answer: all (a), (b) and (c).
Correct Answer: Silicon carbide
Correct Answer: Resistance to abrasion.
Correct Answer: neither (a) nor (b).
Correct Answer: required to resist corrosive basic slag.
Correct Answer: resistance to slag penetration
Correct Answer: both a & b
Correct Answer: polystyrene
Correct Answer: 250-280
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.