Discussion
Home ‣ Chemical Engineering ‣ Refractory Technology Comments
- Question
Fireclay bricks are used in the
Options- A. coke ovens regenerator.
- B. outer lining of L.D. converter.
- C. hearth bottom of blast furnace.
- D. coke oven walls.
- Correct Answer
- coke ovens regenerator.
- 1. Firing temperature of magnesite bricks is about __________ °C.
Options- A. 800-1000
- B. 1000-1200
- C. 1600-1800
- D. 2400-2600 Discuss
- 2. Spalling of silica bricks occurs due to abrupt volume changes, when it is cooled below a temperature of __________ °C.
Options- A. 770
- B. 570
- C. 270
- D. 70 Discuss
- 3. Maximum alumina content in high alumina refractory can be as high as __________ percent.
Options- A. 30
- B. 50
- C. 70
- D. 90 Discuss
- 4. Firing of refractory brick is done to
Options- A. dehydrate the dried refractory.
- B. develop stable mineral forms in them.
- C. form ceramic bonds necessary for development of high crushing strength in the finished product.
- D. all (a), (b) and (c). Discuss
- 5. Which is the stable form of silica below 870°C?
Options- A. Tridymite
- B. Cristobalite
- C. Quartz
- D. None of these Discuss
- 6. Panel test determines the __________ of refractories.
Options- A. fusion point
- B. spalling resistance
- C. slag penetration resistance
- D. refractoriness under load (RUL) Discuss
- 7. Vacuum steel degassing units are lined with
Options- A. silica bricks
- B. low duty firebricks
- C. high alumina bricks
- D. graphite blocks Discuss
- 8. Fusion point of a basic refractory material is
Options- A. reduced by the addition of acid oxides.
- B. increased by the addition of acid oxides.
- C. not affected by the addition of acid oxides.
- D. always less than 1000°C. Discuss
- 9. Roof of a basic electric furnace is made of __________ bricks.
Options- A. superduty fireclay
- B. silica
- C. chromite
- D. none of these Discuss
- 10. An insulating refractory brick should have high porosity and low thermal conductivity. Which of the following is not used for inducing porosity in the insulating refractory bricks during its manufacture?
Options- A. Cork
- B. Saw dust
- C. Sand
- D. Chemically prepared foam Discuss
Refractory Technology problems
Search Results
Correct Answer: 1600-1800
Correct Answer: 270
Correct Answer: 90
Correct Answer: all (a), (b) and (c).
Correct Answer: Quartz
Correct Answer: spalling resistance
Correct Answer: high alumina bricks
Correct Answer: reduced by the addition of acid oxides.
Correct Answer: silica
Correct Answer: Sand
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.