logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Fuels and Combustion Comments

  • Question
  • Pensky-Marten apparatus is used for those oils, whose flash points are __________ °F.


  • Options
  • A. <120
  • B. >120
  • C. <90
  • D. 90-110

  • Correct Answer
  • >120 


  • Fuels and Combustion problems


    Search Results


    • 1. Adiabatic flame temperature of a fuel is dependent on the initial temperature of

    • Options
    • A. fuel
    • B. air
    • C. both (a) & (b)
    • D. neither (a) nor (b)
    • Discuss
    • 2. Stack heat losses can be minimised by

    • Options
    • A. controlling the excess air.
    • B. oxygen enrichment of combustion air.
    • C. using low c.v. fuels.
    • D. maintaining proper draft in the furnace.
    • Discuss
    • 3. Gross & net calorific value is the same for

    • Options
    • A. blast furnace gas
    • B. coke oven gas
    • C. L.D. converter gas
    • D. none of these
    • Discuss
    • 4. Which of the following is not used as a binder in coal briquetting?

    • Options
    • A. Tar
    • B. Molasses
    • C. Pitch
    • D. Line
    • Discuss
    • 5. During Joule-Thomson expansion of gases

    • Options
    • A. enthalpy remains constant.
    • B. entropy remains constant.
    • C. temperature remains constant.
    • D. none of these.
    • Discuss
    • 6. In high temperature carbonisation of coal compared to low temperature carbonisation

    • Options
    • A. yield of ammonia is less.
    • B. aromatic content of tar is low.
    • C. H2 content in the coke oven gas is more.
    • D. calorific value of the coke oven gas is lower.
    • Discuss
    • 7. Yield of coke oven gas in low temperature carbonisation of coal is about __________ Nm3 /ton of dry coal.

    • Options
    • A. 60
    • B. 160
    • C. 500
    • D. 750
    • Discuss
    • 8. Which of the following gaseous fuels has the lowest calorific value?

    • Options
    • A. Gobar gas
    • B. Refinery gas
    • C. Converter gas
    • D. Blast furnace gas
    • Discuss
    • 9. The temperature at which plastic layer formation takes place during carbonisation of coal varies from __________ °C.

    • Options
    • A. 100 to 150
    • B. 350 to 450
    • C. 550 to 650
    • D. 700 to 850
    • Discuss
    • 10. Gross and net calorific value of a fuel will be the same

    • Options
    • A. if its ash content is zero.
    • B. ifits carbon content is very low.
    • C. if its hydrogen/hydrogen compound content is zero.
    • D. under no circumstances.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment