Discussion
Home ‣ Chemical Engineering ‣ Mass Transfer Comments
- Question
Chemisorption (chemical adsorption) is
Options- A. same as "Van der Waals" adsorption.
- B. characterised by adsorption of heat.
- C. an irreversible phenomenon.
- D. a reversible phenomenon.
- Correct Answer
- an irreversible phenomenon.
- 1. The amount of steam required per unit quantity of distillate in case of steam distillation will be reduced by
Options- A. raising the temperature.
- B. lowering the total pressure.
- C. both (a) and (b).
- D. neither (a) nor (b). Discuss
- 2. In a solution containing 0.30 Kg mole of solute and 600 kg of solvent, the molality is
Options- A. 0.50
- B. 0.60
- C. 2
- D. 1 Discuss
- 3. Which of the following liquid-vapor contacting devices provides maximum contact surface area for a particular duty?
Options- A. Sieve plate column
- B. Bubble cap column
- C. Randomly packed column
- D. Wetted wall column Discuss
- 4. Separation of two or more components of a liquid solution can not be achieved by
Options- A. fractional crystallisation
- B. liquid extraction
- C. absorption
- D. evaporation Discuss
- 5. Relative humidity is the ratio of the
Options- A. partial pressure of the vapour to the vapour pressure of the liquid at room temperature.
- B. partial pressure of the vapour to the vapour pressure of the liquid at gas temperature.
- C. actual humidity to saturation humidity.
- D. none of these Discuss
- 6. On addition of solute in the solvent, the __________ of the solution decreases.
Options- A. boiling point
- B. freezing point
- C. vapour pressure
- D. both (b) and (c) Discuss
- 7. In case of an absorber, the operating
Options- A. line always lies above the equilibrium curve.
- B. line always lies below the equilibrium curve.
- C. line can be either above or below the equilibrium curve.
- D. velocity is more than the loading velocity. Discuss
- 8. In distillation, overhead product contains
Options- A. only one component
- B. two components
- C. any number of components
- D. only saturated liquid Discuss
- 9. Drying operation under vacuum is carried out to
Options- A. dry those materials which have very high unbound mositure content.
- B. reduce drying temperature.
- C. increase drying temperature.
- D. dry materials having high bound moisture content. Discuss
- 10. Heat in BTU necessary to increase the temperature of 1 lb of gas and its accompanying vapour by 1°F is called the
Options- A. latent heat
- B. humid heat
- C. specific heat
- D. sensible heat Discuss
Mass Transfer problems
Search Results
Correct Answer: both (a) and (b).
Correct Answer: 0.50
Correct Answer: Wetted wall column
Correct Answer: absorption
Correct Answer: partial pressure of the vapour to the vapour pressure of the liquid at gas temperature.
Correct Answer: both (b) and (c)
Correct Answer: line always lies above the equilibrium curve.
Correct Answer: any number of components
Correct Answer: reduce drying temperature.
Correct Answer: specific heat
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.