logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Heat Transfer Comments

  • Question
  • Air is best heated with steam in a heat exchanger of


  • Options
  • A. plate type.
  • B. double pipe type with fin on steam side.
  • C. double pipe type with fin on air side.
  • D. shell and tube type.

  • Correct Answer
  • double pipe type with fin on air side. 


  • Heat Transfer problems


    Search Results


    • 1. Pick out the wrong statement.

    • Options
    • A. Orifice baffles are never used in a shell and tube heat exchanger.
    • B. Pressure drop on the shell side of a heat exchanger depends upon tube pitch also.
    • C. In a horizontal tube evaporator, surface blanketing by air is avoided.
    • D. Split ring type and pull through type floating heads are two commonly used floating heads is heat exchangers.
    • Discuss
    • 2. Heat produced when a steady state current, I passes through an electrical conductor having resistance, 'R' is

    • Options
    • A. IR
    • B. I2R
    • C. IR2
    • D. I2R2
    • Discuss
    • 3. Fourier's law applies to the heat transfer by

    • Options
    • A. convection
    • B. radiation
    • C. conduction
    • D. all (a), (b) & (c)
    • Discuss
    • 4. Shell side pressure drop in a shell and tube heat exchanger does not depend upon the

    • Options
    • A. baffle spacing & shell diameter.
    • B. tube diameter & pitch.
    • C. viscosity, density & mass velocity of shell side fluid.
    • D. none of these.
    • Discuss
    • 5. Crystal size in a continuous crystalliser depends upon the

    • Options
    • A. rate of heat transfer.
    • B. degree of turbulence.
    • C. degree of supersaturation.
    • D. all (a), (b) and (c).
    • Discuss
    • 6. The equivalent diameter for pressure drop is __________ that for heat transfer.

    • Options
    • A. smaller than
    • B. greater than
    • C. equal to
    • D. not related with
    • Discuss
    • 7. Which is the controlling factor for a drum drier?

    • Options
    • A. Diffusion
    • B. Heat transfer
    • C. Both (a) and (b)
    • D. Neither (a) nor (b)
    • Discuss
    • 8. When the temperature and humidity of air is low, we usually use __________ draft cooling tower.

    • Options
    • A. natural
    • B. forced
    • C. induced
    • D. none of these
    • Discuss
    • 9. Mass transfer rate between two fluid phases does not necessarily depend on the __________ of the two phases.

    • Options
    • A. chemical properties
    • B. physical properties
    • C. degree of turbulence
    • D. interfacial area
    • Discuss
    • 10. With increase in pressure, the relative volatility for a binary system

    • Options
    • A. increases.
    • B. decreases.
    • C. remains same.
    • D. either (a) or (b), depends on the system.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment