Discussion
Home ‣ Chemical Engineering ‣ Heat Transfer Comments
- Question
Which of the following is not used as a medium for high temperature heating?
Options- A. Dowtherm
- B. mercury
- C. liquid metal (e.g. molten sodium)
- D. fused salts (e.g., an eutectic mixture of 53% KNO3, 40% NaNO2and 7% NaNO3)
- Correct Answer
- mercury
- 1. Presence of a non-condensing gas in a condensing vapour
Options- A. increases the rate of condensation.
- B. decreases thermal resistance.
- C. is desirable to increase the film co-efficient.
- D. none of these. Discuss
- 2. Heat waves
Options- A. can not pass through vacuum.
- B. travel in straight line.
- C. can be reflected by a mirror.
- D. both (b) and (c). Discuss
- 3. With increase in porosity, the thermal conductivity of a solid substance
Options- A. increases
- B. decreases
- C. remains unchanged
- D. may increase or decrease; depends on the solid Discuss
- 4. A process stream of dilute aqueous solution flowing at the rate of10 Kg.s-1 is to be heated. Steam condensate at 95°C is available for heating purpose, also at a rate of 10 Kg.s-1. A 1 - 1 shell and tube heat exchanger is available. The best arrangement is
Options- A. counter flow with process stream on shell side.
- B. counter flow with process stream on tube side.
- C. parallel flow with process stream on shell side.
- D. parallel flow with process stream on tube side. Discuss
- 5. Which of the following is concerned with both heat and mass transfer?
Options- A. Lewis relationship
- B. Nusselt number
- C. Kutateladze number
- D. Froude number Discuss
- 6. Convective heat transfer co-efficient in case of fluid flowing in tubes is not affected by the tube length/diameter ratio, if the flow is in the __________ zone.
Options- A. laminar
- B. transition
- C. both 'a' & 'b'
- D. highly turbulent Discuss
- 7. Increasing the liquor level in the evaporator results in the
Options- A. decreased capacity.
- B. increase in liquor film co-efficient.
- C. decreased effect of hydrostatic head.
- D. increased true temperature drop. Discuss
- 8. The average heat transfer co-efficient for laminar film condensation on vertical surface is inversely proportional to (where, ?T = Temperature drop across condensate film )
Options- A. (?T)2
- B. ?T
- C. (?T)1/4
- D. (?T)3/2 Discuss
- 9. In case of evaporators, liquid entrainment results primarily due to
Options- A. high vacuum in the evaporator.
- B. high evaporation rate.
- C. foaming of the solution.
- D. high heat transfer rate. Discuss
- 10. A backward feed multiple effect evaporator is better than forward feed for concentrating cold feed, because it provides
Options- A. higher economy
- B. lower capacity
- C. both (a) & (b)
- D. lower economy Discuss
Heat Transfer problems
Search Results
Correct Answer: none of these.
Correct Answer: both (b) and (c).
Correct Answer: decreases
Correct Answer: counter flow with process stream on shell side.
Correct Answer: Lewis relationship
Correct Answer: highly turbulent
Correct Answer: decreased capacity.
Correct Answer: (?T)1/4
Correct Answer: foaming of the solution.
Correct Answer: higher economy
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.