Discussion
Home ‣ Chemical Engineering ‣ Chemical Engineering Basics Comments
- Question
The softness or hardness of a grinding wheel depends upon the type & amount of bonding material used. For general purpose cutter grinding __________ grinding wheel is normally used.
Options- A. hard
- B. soft
- C. silicon carbide
- D. aluminium oxide
- Correct Answer
- aluminium oxide
- 1. Area under the stress-strain curve upto the __________ is referred to as the modulus of resilience.
Options- A. yield strength
- B. elastic limit
- C. proportional limit
- D. maximum point Discuss
- 2. Absolute zero pressure can be attained at a temperature of
Options- A. 0°C
- B. 50°K
- C. 0°R
- D. none of these Discuss
- 3. Resistance of an electrical conductor is proportional to its (where, l = length and A = cross-sectional area of the conductor)
Options- A. A
- B. l
- C. A2
- D. both 'a' & 'b' Discuss
- 4. Chromium molybdenum steel can not be welded using __________ welding.
Options- A. thermit
- B. electrical resistance
- C. oxy-acetylene
- D. any of these Discuss
- 5. Which of the following is not an explosive?
Options- A. TNT
- B. CMC
- C. RDX
- D. Lead azide Discuss
- 6. Electrical conductivities of semi-conductors are of the order of __________ ohm/cm.
Options- A. 10-3
- B. 103
- C. 10-15
- D. l015 Discuss
- 7. Friction factor for fluid flow in pipe does not depend upon the
Options- A. pipe length.
- B. pipe roughness.
- C. fluid density & viscosity.
- D. mass flow rate of fluid. Discuss
- 8. Fog is an example of colloidal system of
Options- A. solid dispersed in gas.
- B. solid dispersed in liquid.
- C. liquid dispersed in gas.
- D. gas dispersed in liquid. Discuss
- 9. The most economical channel section for the fluid flow is the one for which the discharge is maximum for a given cross-sectional area. Vertical velocity distribution in an open channel for laminar flow can be assumed to be
Options- A. parabolic
- B. hyperbolic
- C. straight line
- D. none of these Discuss
- 10. The product out from a cupola is called
Options- A. wrought iron
- B. pig iron
- C. cast iron
- D. none of these Discuss
Chemical Engineering Basics problems
Search Results
Correct Answer: proportional limit
Correct Answer: 0°R
Correct Answer: both 'a' & 'b'
Correct Answer: electrical resistance
Correct Answer: CMC
Correct Answer: 10-3
Correct Answer: pipe length.
Correct Answer: liquid dispersed in gas.
Correct Answer: parabolic
Correct Answer: cast iron
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.