Discussion
Home ‣ Electrical Engineering ‣ RLC Circuits and Resonance Comments
- Question
If the resistance in parallel with a parallel resonant circuit is reduced, the bandwidth
Options- A. disappears
- B. becomes sharper
- C. increases
- D. decreases
- Correct Answer
- decreases
- 1. A 10 Ω resistor, a 90 mH coil, and a 0.015 µF capacitor are in series across an ac source. The impedance magnitude at 1,200 Hz below fr is
Options- A. 1,616 Ω
- B. 161 Ω
- C. 3,387 Ω
- D. 1,771 Ω Discuss
- 2. In a certain series resonant circuit, VC = 125 V, VL = 125 V, and VR = 40 V. The value of the source voltage is
Options- A. 125 V
- B. 250 V
- C. 290 V
- D. 40 V Discuss
- 3. In a series RLC circuit that is operating above the resonant frequency, the current
Options- A. lags the applied voltage
- B. leads the applied voltage
- C. is in phase with the applied voltage
- D. is zero Discuss
- 4. A 15 Ω resistor, a 220 µH coil, and a 60 pF capacitor are in series across an ac source. What is the bandwidth of the circuit?
Options- A. 138 MHz
- B. 10,866 Hz
- C. 1,907 Hz
- D. 138 kHz Discuss
- 5. A 9 mH coil is in parallel with a 0.015 µF capacitor across an 18 kHz ac source. The coil's internal resistance, RW, is 60 Ω. The circuit impedance is
Options- A. 17,340 Ω
- B. 1,734 Ω
- C. 290 Ω
- D. 1,018 Ω Discuss
- 6. A 6.8 kΩ resistor, a 7 mH coil, and a 0.02 µF capacitor are in parallel across a 17 kHz ac source. The coil's internal resistance, RW, is 30 Ω. The equivalent parallel resistance, Rp(eq), is
Options- A. 1,878 Ω
- B. 18,780 Ω
- C. 18,750 Ω
- D. 626 Ω Discuss
- 7. A certain series RLC circuit with a 200 Hz, 15 V ac source has the following values: R = 12 Ω, C = 80 µF, and L = 10 mH. The total impedance, expressed in polar form, is
Options- A. 12.28∠12.34° Ω
- B. 12.57∠12.34° Ω
- C. 9.95∠12.34° Ω
- D. 12.62∠12.34° Ω Discuss
- 8. A 24 Ω resistor, an inductor with a reactance of 120 Ω, and a capacitor with a reactance of 120 Ω are in series across a 60 V source. The circuit is at resonance. The voltage across the inductor is
Options- A. 60 V
- B. 660 V
- C. 30 V
- D. 300 V Discuss
- 9. To tune a parallel resonant circuit to a higher frequency, the capacitance should be
Options- A. increased
- B. decreased
- C. left alone
- D. replaced with inductance Discuss
- 10. The impedance at the resonant frequency of a series RLC circuit with L = 20 mH, C = 0.02 µF, and RW = 90 Ω is
Options- A. 0 Ω
- B. 90 Ω
- C. 20 kΩ
- D. 40 kΩ Discuss
RLC Circuits and Resonance problems
Search Results
Correct Answer: 1,616 Ω
Correct Answer: 40 V
Correct Answer: lags the applied voltage
Correct Answer: 10,866 Hz
Correct Answer: 17,340 Ω
Correct Answer: 18,780 Ω
Correct Answer: 12.28∠12.34° Ω
Correct Answer: 300 V
Correct Answer: decreased
Correct Answer: 90 Ω
Comments
There are no comments.More in Electrical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.