A loss less line of characteristic impedance Z₀ is terminated in pure reactance of -jZ₀ value. VSWR is

A TWT is a broadband device. Its main components are electron gun (to produce the electron beam) and a structure supporting the slow electromagnetic wave.

The velocity of wave propagation along the helix structure is less than velocity of light.

The beam and wave travel along the structure at the same speed.

Thus interaction occurs between beam and wave and the beam delivers energy to the RF wave.

Therefore the signal gets strengthened and amplified output is delivered at the other end of tube.

The main features of TWT are :

1. Frequency range - 0.5 GHz to 90 GHz

2. Power output - 5 mW at low frequencies(less than 20 GHz) 250 kW (continuous wave) at 3 GHz 10 MW (pulsed) at 3 GHz

3. Efficiency - about 5 to 20%

4. Noise - about 5 dB for low power TWT 25 dB for high power TWT

TWT is used as RF amplifier in broadband microwave receivers, repeater amplifier in broad band communication systems, communication satellites etc.

These analysis uses cylindrical coordinates.

In circular waveguide TE₁₁ mode has the lowest cut off frequency and is the dominant mode.

If D is diameter of waveguide

?_c = 1.706 D for TE₁₁ mode

?_c = 1.029 D for TE₂₁ mode

?_c = 0.82 D for TE₀₁ mode

?_c = 1.306 D for TM₀₁ mode.

It has an electron gun and a helix structure. However the interaction between electron beam and RF wave is different than in TWT.

The growing RF wave travels in opposite direction to the electron beam.

The frequency of wave can be changed by changing the voltage which controls the beam velocity.

Moreover the amplitude of oscillations can be decreased continuously to zero by changing the beam current.

It features are:

1. Frequency range - 1 GHz to 1000 GHz.

2. Power output - 10 mV to 150 mW (continuous wave) 250kW (pulsed).

It is used as signal source in transmitters and instruments.

Its special feature is easy access to top surface so that minor adjustments can be made after circuit fabrication.

The high dielectric constant of the substrate reduces guide wavelength and circuit dimensions.

A microstrip line is the most commomly used transmission structure for microwave integrated circuits.