logo

CuriousTab

CuriousTab

Discussion


Home Electronics and Communication Engineering Networks Analysis and Synthesis Comments

  • Question
  • The terms RMS and average values apply only to sine waves.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • False 

    Explanation
    These terms are applicable to all waveshapes.

    Networks Analysis and Synthesis problems


    Search Results


    • 1. In a parallel resonant circuit, the circuit current at resonance is maximum.

    • Options
    • A. True
    • B. False
    • Discuss
    • 2. The drift velocity of electrons is

    • Options
    • A. very small as compared to speed of light
    • B. equal to speed of light
    • C. almost equal to speed of light
    • D. half the speed of light
    • Discuss
    • 3. A series RL circuit has . If a voltage 4 sint + 4t is applied, the steady state current will be

    • Options
    • A. 4 sin (4t - 45°)
    • B.
    • C.
    • D.
    • Discuss
    • 4. A cable has an insulation resistance of 1010 ohms. If the length is doubled, the insulation resistance will be

    • Options
    • A. 2 x 1010 ?
    • B. 0.5 x 1010 ?
    • C. 1010 ?
    • D. 4 x 1010 ?
    • Discuss
    • 5. In figure, the current supplied by battery immediately after switching on the circuit is

    • Options
    • A. 1 A
    • B. 4 A
    • C. 10 A
    • D. 0
    • Discuss
    • 6. In an ac circuit, the maximum and minimum values of power factor can be

    • Options
    • A. 2 and 0
    • B. 1 and 0
    • C. 0 and -1
    • D. 1 and -1
    • Discuss
    • 7. The synthesis of minimum function was suggested by

    • Options
    • A. O'Brune
    • B. R. Richards
    • C. Bott and Duffin
    • D. none of the above
    • Discuss
    • 8. Wave A = 100 sin ?t and wave B = 100 cos ?t. Then

    • Options
    • A. rms values of the two waves are equal
    • B. rms values of A is more than that of B
    • C. rms values of A is less than that of B
    • D. rms values of the two waves may or may not be equal
    • Discuss
    • 9. Which of the following measurements using a dc potentiometer do not require standardisation of potentiometer?

    • Options
    • A. Measurement of unknown voltage
    • B. Measurement of resistance
    • C. Measurement of unknown current
    • D. Calibration of voltmeter
    • Discuss
    • 10. The coil of a moving coil meter has 100 turns, is 40 mm long and 30 mm wide. The control torque is 240 x 10-6 N-m on full scale. If B = 1 Wb/m2, range of meter is

    • Options
    • A. 1 mA
    • B. 2 mA
    • C. 3 mA
    • D. 4 mA
    • Discuss


    Comments

    There are no comments.

Enter a new Comment