Purlins are provided, in industrial buildings, over roof trusses to carry dead l

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Civil Engineering ‣ UPSC Civil Service Exam Questions Comments

Question
Purlins are provided, in industrial buildings, over roof trusses to carry dead loads, live loads and wind loads. As per IS code, what are they assumed to be?
Options
A. Simply supported
B. Cantilever
C. Continuous
D. Fixed

Correct Answer

Continuous

UPSC Civil Service Exam Questions problems

Search Results

3. A short column of external diameter D and internal diameter d, is subjected to a load W, with an eccentricity 'e', causing zero stress at an extreme fibre. Then the value of 'e' must be
Options
A.
B.
C.
D.

4. A plot of land 60�m x 20 m is measure steel tape. If the standard error of length width measurements is taken as � 1 cm, the standard error of the area of the plot be
Options
A. � 0.1414 m²
B. � 0.566 m²
C. � 0.632 m²
D. � 0.8484 m²

5. For designing end bearing piles of square cross-section in clays having average unconfmed compressive strength of 6 t/m², the net ultimate bearing capacity may be taken as
Options
A. 15 t/m²
B. 18 t/m²
C. 20 t/m²
D. 27 t/m²

6. The ratio of total elongation of a bar of uniform cross-section produced under its own weight to the elongation produced by an external load equal to the weight of the bar is
Options
A. 2
B. 1
C. 1/2
D. 1/4

7. The rectangular block shown in the given figure is subjected to pure shear to intensity 'q'. If BE represents the i principal plane and the principal stresses are ?₁, ?₂ ; then the values of ?, ?₁ and ?₂ will be respectively.
Options
A. ?�, 90�; + q and - q
B. 30�, 120�; + q and - q
C. 45�, 135�; + and
D. 45�, 135�; + q and - q

8. According to ICAO recommendations, what is the rate of elevation correction for the runway above MSL?
Options
A. 1 % for every 100 m of elevation above MSL
B. 7 % for every 300 m of elevation above MSL
C. 2 % for every 500 m of elevation above MSL
D. 2 % for every 300 m of elevation above MSL

9. Consider the following statements :
Sand in mortar is needed for
1. decreasing the quantity of cement.
2. reducing shrinkage.
3. decreasing the surface area of the binding material.
4. increasing the strength.
Of these statements :
Options
A. 2, 3 and 4 are correct
B. 1, 2 and 3 are correct
C. 1, 3 and 4 are correct
D. 1, 2 and 4 are correct

10. A cold drawn seamless steel tubing subject to internal pressure, has a diameter of 6 cm and wall thickness of 0.2 cm. The ultimate strength of steel is 3600 kg/cm². The bursting pressure (in kg/cm²) is
Options
A. 120
B. 240
C. 480
D. 960

Comments

More in Civil Engineering: