Discussion
Home ‣ Mechanical Engineering ‣ Automobile Engineering Comments
- Question
The flywheel and the pressure plate bind the clutch disc between them so that the engine and the transmission can be engaged.
Options- A. Yes
- B. No
- Correct Answer
- Yes
- 1. What type of bearing is used for main bearings and connecting rod bearings?
Options- A. Ballbearings
- B. Plain bearings
- C. Needle roller bearing
- D. Taper roller bearing Discuss
- 2. The co-efficient of rolling resistance for a truck weighing 63 500 N is 0.018. The rolling resistance to the truck is
Options- A. 1.143 N
- B. 11.43 N
- C. 114.3 N
- D. 1143 N Discuss
- 3. The natural gas is compressed in a CNG cylinder at a pressure of
Options- A. 200 bar
- B. 220 bar
- C. 250 bar
- D. 300 bar Discuss
- 4. The cetane rating of Diesel fuel is in the order of
Options- A. 25
- B. 45
- C. 70
- D. 90 Discuss
- 5. In a fuel injection system, the electronic control module (ECM) calculates the optimum fuel-injection volume for the engine condition based on the data received from the sensors, and injects this volume of fuel into the intake manifold at the optimum timing.
Options- A. Correct
- B. Incorrect Discuss
- 6. The valve overlap in four stroke petrol engines is approximately
Options- A. 30°
- B. 60°
- C. 90°
- D. 120° Discuss
- 7. It is necessary to maintain the valve clearances as they
Options- A. reduce the resistance to sliding that occurs between the cam and the tappet
- B. allow for lengthening of the valves owing to the heat of combustion
- C. increase the speed at which the valves move up and down
- D. make the crankshaft turn smoothly Discuss
- 8. The torque available at the contact between driving wheels and road is known as
Options- A. brake effort
- B. tractive effort
- C. clutch effort
- D. none of these Discuss
- 9. The effect of having excess camber is
Options- A. excessive steering alignment torque
- B. hard steering
- C. too much traction
- D. uneven tyre wear Discuss
- 10. The main function of intake manifold is that it
Options- A. promotes the mixture of air and fuel
- B. reduces intake noise
- C. cools the intake air to a suitable temperature
- D. distributes intake air equally to the cylinders Discuss
Automobile Engineering problems
Search Results
Correct Answer: Plain bearings
Correct Answer: 1143 N
Correct Answer: 200 bar
Correct Answer: 45
Correct Answer: Correct
Correct Answer: 30°
Correct Answer: allow for lengthening of the valves owing to the heat of combustion
Correct Answer: tractive effort
Correct Answer: uneven tyre wear
Correct Answer: distributes intake air equally to the cylinders
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.