Discussion
Home ‣ Mechanical Engineering ‣ Automobile Engineering Comments
- Question
A clutch is usually designed to transmit maximum torque which is
Options- A. equal to the maximum engine torque
- B. 80 per cent of the maximum engine torque
- C. 150 per cent of the maximum engine torque
- D. none of these
- Correct Answer
- 150 per cent of the maximum engine torque
- 1. Positive camber is used to compensate for wheels tilting inward due to the weight of the vehicle.
Options- A. Yes
- B. No Discuss
- 2. Which of the following symptom is caused as a result of brake disc run out?
Options- A. Ineffectiveness of the brakes
- B. Judder during braking
- C. Localized wearing of the brake pads
- D. Rapid wearing of the brake pads Discuss
- 3. The condition that causes vapour locking in a brake system is
Options- A. overheating of the fluid due to frequent brake application
- B. overcooling of the brakes during high speed driving
- C. keeping the vehicle without use for an extended period
- D. an excessively high engine speed on a downhill road Discuss
- 4. The component that connects the steering rack to the knuckles is
Options- A. tie-rod
- B. sector gear
- C. pivot
- D. spline Discuss
- 5. The coefficient of friction for the clutch facing is approximately
Options- A. 0.1
- B. 0.4
- C. 0.8
- D. 1.2 Discuss
- 6. The firing order for an in-line four cylinder I.C. engine is
Options- A. 1-2-3-4
- B. 1-3-4-2
- C. 1-2-4-3
- D. 1-3-2-4 Discuss
- 7. The air gap between the central electrode and ground (or side) electrode of a spark plug is around
Options- A. 0.2 mm
- B. 0.5 mm
- C. 1 mm
- D. 1.5 mm Discuss
- 8. The information provided by the oxygen (O2) sensor to the feedback control system is about the
Options- A. air-fuel ratio
- B. air temperature
- C. air flow speed
- D. exhaust gas volume Discuss
- 9. The vehicle ride will be comfortable if
Options- A. unsprung mass is kept minimum
- B. sprang mass is kept minimum
- C. vehicle mass is kept minimum
- D. all of these Discuss
- 10. If the engine coolant leaks into the engine oil, then engine oil
Options- A. appears milky
- B. becomes foamy
- C. turns black
- D. none of these Discuss
Automobile Engineering problems
Search Results
Correct Answer: Yes
Correct Answer: Judder during braking
Correct Answer: overheating of the fluid due to frequent brake application
Correct Answer: tie-rod
Correct Answer: 0.4
Correct Answer: 1-3-4-2
Correct Answer: 1 mm
Correct Answer: air-fuel ratio
Correct Answer: unsprung mass is kept minimum
Correct Answer: appears milky
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.